User manual YAMAHA SILENT BRASS PICKUP MUTE

[. . . ] Pickup Mute Owner's Manual Bedienungsanleitung Mode d'emploi Manual de instrucciones Español Français Deutsch English Yamaha Silent Brass Pickup Mute Thank you for purchasing the Yamaha Silent Brass Pickup Mute. In order to obtain the maximum performance and enjoyment from your Pickup Mute, we urge you to read this Owner's Manual thoroughly before using. [. . . ] Please study this manual carefully and consult your dealer before requesting service. Disposal Notice: Should this product become damaged beyond repair, or for some reason its useful life is considered to be at an end, please observe all local, state, and federal regulations that relate to the disposal of products that contain lead, batteries, plastics, etc. If your dealer is unable to assist you, please contact Yamaha directly. Handling and Transport · Never apply excessive force to the controls, connectors or other parts. · Always unplug cables by gripping the plug firmly, not by pulling on the cable. · Physical shocks caused by dropping, bumping, or placing heavy objects on the unit can result in scratches and more serious damage. Cleaning · Clean the cabinet and panel with a dry soft cloth. · A slightly damp cloth may be used to remove stubborn grime and dirt. YAMAHA is not responsible for damage caused by improper handling or operation. 92-BP 13 Set up and Use Personal Studio ST7 Connecting Cable PICKUP MUTE 1 2 PHONES 1 2 Stereo Earphone PM7 for TRUMPET PM6 for FLUGELHORN Lock Nut PM5 for TROMBONE Hand Rest (P. 17) PM3 for FRENCH HORN PM2 for EUPHONIUM Handle 14 Before connecting the cable and attaching the mute, make sure the power is switched OFF and the earphones are removed from your ears. PICKUP MUTE 1 2 PHONES 1 2 Stereo Earphone Head Connecting Cable Handle Body Lock Nut Assembling the PM1 1. Inner Head Lay the Head on the floor. hook 2. Place the Body on the Head and fasten with the three hooks. 3. Fully extend the Inner Head that is located in the center of the Head. PM1 for TUBA * Refer to pg. 16 for instructions on attaching the mute to the instrument. 15 QUICK GUIDE Attaching and removing the pickup mute Attach the Pickup Mute to the Tuba As shown in the illustration, hold the instrument with your left hand and, while turning the pickup mute, firmly insert it into the bell with your right hand. 1. For Euphoniums, with the bell facing up, hold the PM2 by its handle in your right hand and firmly insert it into the bell. After assembling the Pickup Mute (refer to pg. Hold the Pickup Mute by its handle and lift it up. 2. Holding the Pickup Mute with both hands, gently insert the Inner Head into the bell of the tuba. (Continue holding the tuba between your legs. ) 3. Adjust the Pickup Mute so that it is positioned in the center of the bell. [. . . ] When you are finished playing, remove the PICKUP MUTE from the instrument. DO NOT WASH WITH WATER. 17 QUICK GUIDE Insert firmly Signal path REHEARSAL ROOM CONCERT HALL CHURCH REVERB MODE From PHONES 1 Tighten the Lock Nut Connect the supplied cable to the PICKUP MUTE output jack and tighten the LOCK NUT. AUX IN REVERB LEVEL PLAYER 2 MASTER VOLUME PLAYER 1 To PICKUP MUTE 1 Don't step on the cable * Personal Studio ST7 and stereo earphone are not included. Disconnecting the cable while the power is ON may result in damage to the unit. [. . . ]