User manual WHIRLPOOL AZB9780

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL AZB9780. We hope that this WHIRLPOOL AZB9780 user guide will be useful to you.


WHIRLPOOL AZB9780 : Download the complete user guide (112 Ko)

Manual abstract: user guide WHIRLPOOL AZB9780

Detailed instructions for use are in the User's Guide.

[. . . ] • Light bulb replacement must only be carried out by the After-Sales Service. Installation • Do not install your dryer where it may be exposed to extreme conditions, such as: poor ventilation, temperature below 5°C or above 35°C. • The appliance must not be installed behind a lockable door, a sliding door or a door with hinges on the opposite side to that of the tumble dryer, in such a way as to prevent the tumble dryer door from being fully opened. • Small indoor located storage rooms, bathrooms, toilets, shower rooms and enclosed areas without ventilation are not suitable locations for installation of the dryer. [. . . ] If the heat cannot escape, the item can become hot enough to catch fire. Piling, stacking or storing oil-soaked items can prevent heat from escaping and so create a fire hazard. • Ensure that the appliance is maintained as shown in the section “Maintenance and cleaning”. • Ensure that the appliance is installed as per the instructions above. • Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers must be washed in hot water with an extra amount of detergent before being dried in the tumble dryer. • Do not use the tumble dryer if chemicals have been used for cleaning. • Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads must not be dried in the tumble dryer. • Fabric softeners or similar products should be used as specified in the fabric softener instructions. • Never stop a tumble dryer before the end of the drying cycle, unless all items are quickly removed and spread out so that the heat is dissipated. • This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). • By ensuring that this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. 6 ELECTRICAL CONNECTION 1) For United Kingdom only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an ASTA marked fuse, approved to BS 1362 and proceed as follows: 1. If the fuse cover is lost, the plug must not be used until a correct replacement is fitted. Correct replacements are identified by the colour insert or by the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. 2) For the Republic of Ireland only The information given in respect of United Kingdom will frequently apply, but a third type of plug and socket is also used, the 2-pin type with side earth terminal. 3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instructions. This procedure must be carried out by a qualified Whirlpool technician in compliance with the manufacturer’s instructions and current safety regulations. 7 DESCRIPTION OF THE DRYER A. Heat exchanger flap REMINDER - MAINTENANCE AND CLEANING Before cleaning or carrying out maintenance, switch off the dryer. AFTER EACH DRYING CYCLE • Clean the lint filter at the end of every drying cycle. • Empty the water container at the end of each drying cycle. EACH MONTH • Clean the heat exchanger at least every month (see “Cleaning the heat exchanger” on the next page). CLEANING THE LINT FILTER Depending on the model of your dryer, the lint filter can have different shapes. Clean the lint filter after every drying cycle, or when the lint filter indicator lamp lights up, proceeding as follows: A. Make sure that the lint filter is correctly positioned before starting the next drying cycle. A A B 8 B CLEANING THE HEAT EXCHANGER Before cleaning or carrying out maintenance, switch off the dryer. Clean the heat exchanger at least every month, or whenever the heat exchanger indicator lamp lights up (optional feature, depending on the model of your dryer), proceeding as follows. A. [. . . ] pressed Heat exchanger LED blinks 2 Make sure that the heat exchanger is correctly positioned. If the failure reoccurs, please call the After-Sales times when Start Service. button is pressed LED not blinking 12 LED blinking TROUBLESHOOTING GUIDE/ AFTER-SALES SERVICE If a fault occurs, before contacting our AfterSales Service, perform the following checks to try to remedy the problem: Drying takes too long / laundry is not dry enough: • Correct programme selected?• Laundry too wet (Washing machine spin speed less than 1000 rpm? [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL AZB9780




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL AZB9780 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.