User manual VOLTCRAFT PL-120 T2 V07-10

[. . . ] The crossed-out wheeled bin indicates the product needs to be disposed separately and not as municipal waste. Repair works must only be carried out by a specialist/ specialist workshop. [. . . ] Point in time, at which the maximum reading was measured, is displayed at lower edge of the display in minutes and seconds (min:sec) or in hours and minutes (hour:min) · Point in time, at which the minimum reading was measured, is displayed at lower edge of the display in minutes and seconds (min:sec) or in hours and minutes (hour:min) · The running total time of the current measurement process is displayed at lower edge of the display in minutes and seconds (min:sec) or in hours and minutes (hour:min) When in MIN/MAX mode, you can switch between T1, T2 and T1-T2 by pressing the T1/T2 button. Unscrew the screw on the battery compartment cover using a Phillips screwdriver and take off the cover of the battery compartment. We do not assume liability for resulting damages to property or personal injury if the product has been abused in any way or damaged by improper use or failure to observe these operating instructions. Carefully read the whole operating instructions before operating the device, otherwise there is risk of danger. ⷠWhen used in conjunction with other devices, observe the operating instructions and safety notices · Do not measure the temperature of live parts or leads, as touching them might of connected devices. Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture, could be damaged. The sensors included with delivery can only be used for measurements in dry · Do not place the product under any mechanical stress. If it is no longer possible to operate the product safely, take it out of operation and protect it from any are not suitable for use in humid environments or to measure the temperature accidental use. - is visibly damaged , · The accuracy of the gauge is only assured when the thermometer is operated at a - is no longer working properly, temperature range of +18 ºC to +28 ºC (excluding the temperature sensors). - has been stored for extended periods in poor ambient conditions or · The thermometer (excluding the temperature sensors) must not be used outside - has been subjected to any serious transport-related stresses. In schools, training facilities, hobby or self-service workshops, handling of electrical devices must be temperature in the Technical data section. You can utilize the entire measurement range of the thermometer with optionally · Do not switch the product on immediately after it has been taken from a cold to a warm environment. [. . . ] No maintenance is necessary for the device apart for occasional cleaning and the changing of the battery. ⷠClean the exterior of the device with a soft, dry cloth or brush only. [. . . ]