User manual VISA VE-S60

[. . . ] The wall structure must be capable of supporting at least a maximum weight of 75Kgs(165lbs) for 37"-60" televisions and 56kgs(123lbs) for 25"-42" televisions. Proper installation procedure by a qualified service technician, as outlined in the installation instructions, must be adhered to. Failure to do so could result in serious personal injury, or even death. [. . . ] Injury and/or damage can result from dropping or mishandling the display. If the mount is to be installed on any surface other than wooden studs, use suitable hardware (which is commercially available). Before installation, you need measure the horizontal distance of the holes on the back of the television you want to install and get the data. Use pencil to draw a horizontal line on the place you want to install your television, making sure the the line must be horizontal to the ground and at least as wide as the width of the horizontal hole distance on back of your TV. Place the two pieces of wall plate under the horizonal line, making sure the upper edge of the wall plates on the same level with the line and the hole distance falling into the wall plates. Mark the right (upper and lower) and the left (upper and lower) positions of the small horizontal slots in the two wall plates. With the help of an assistant, position the wall plate against the wall and line up the mounting slots with drilled holes. Note: If you install on wood wall, make it sure that all the hole must be on the studs!Tighten bolt with an open ended socket wrench by turning clockwise until tight. CAUTION: Do not over-tighten bolts-doing so may cause unnecessary damage to the wall. CAUTION: Do not release the wall plate until it is properly mounted and secured to the wall. If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall. Once all of the anchors are in place, move the wall plate back into position. Attach the nut onto the threaded shaft that is protruding from the wall. [. . . ] Making sure that the safety-bar is not in place when placing the television on the mount For additional security, you can install the safety-bar that is included with your mount. It should pass through the interspace of the lower part of the two TV brackets. You can also attach a padlock (not included) to the end of the safety-bar to prevent unwanted removal of your TV from the mount. [. . . ]