User manual VISA VE-R60T

[. . . ] Safety measures must be practiced at all times during the installation of this product. Use proper safety gear and tools for the installation procedure to prevent personal injury. Prior to the installation of this product, the installation instructions should be read and completely understood. [. . . ] Mark the right, upper and lower and the left (upper and lower), positions of the small horizontal slots that are in alignment with the studs. With the help of an assistant, position the wall plate against the wall and line up the mounting slots with drilled holes. Tighten bolt with an open ended socket wrench by turning clockwise until tight. CAUTION: Do not over-tighten bolts-doing so may cause unnecessary damage to the wall. CAUTION: Do not release the wall plate until it is properly mounted and secured to the wall. Concrete/Brick Installation NOTE: The concrete anchors must be used for concrete installation. Begin by placing the wall plate into position against the wall, using the bubble level to keep it level. Mark off six holes to be used for securing the mount and place the wall plate aside. If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall. Once all of the anchors are in place, move the wall plate back into position. Attach the nut onto the threaded shaft that is protruding from the wall. TV Plate Assembling After you install the wall plate on your wall, you need assemble the TV plate to the wall plate 1. Attach the TV plate to the front piece of the connecting plates, making sure inner four holes 75x75mm fitting to the four holes on the front plate. Then connect the TV plate with the front piece by inserting 4pcs M8X15 Allen Screws into M8 washers, TV plate, front piece of the connecting plates and finally tightened with M8 nuts. Make sure all four pieces screws has been tightened before you go for next step. To ensure optimal installation, this kit includes various screws of different diameters and lengths. Place your TV screen down on a soft, flat surface, and locate the threaded mounting points that are located on the back of the display. Determine which screw is the correct length by carefully inserting a straw, or toothpick, and mark how deep the mounting point is. [. . . ] You can get 30 degree left or right side view, or make your TV from the wall Max. Other feature of your display mount is the lock designed to prevent your television from being removed from the crossbar. To use the security function, you only need to thread the screws under the TV brackets till it locked the bracket tightly. [. . . ]