User manual VISA VE-PL50T

[. . . ] Before beginning the installation of your new flat screen mount, first verify that you have all of the necessary tools at hand. Electric drill and 5/16" (8mm) masonry bit for concrete/brick installation Also make sure that all of the hardware has been included with your mount. IMPORTANT: Make sure the television is unplugged before starting this step of the installation and never lay your television face down as this can damage the viewing surface. [. . . ] After the knobs are loosened, position your television at the desired level of tilt. Finally, re-tighten the knobs one at a time to lock the tilt level in place (see Diagram E). Other features of your display mount include a cord manager and lock designed to prevent your television from being removed from the cross-bar. The cord manager attaches to the cross-bar and can be used for neatly routing your television's power cable. To use the security lock, locate the small metal tabs located on the arm brackets that attach to the television. Push these tabs inward so that lifting up on the television causes the tabs to come into contact with the cross-bar. Place a small padlock (not included) through the holes located on the tabs and arm brackets to prevent the tabs from being moved out of place (see Diagram F). NOTE: When inserting screws into the top of the mount, make sure the tilt is fully adjusted downward so that the top crossbar is out of the way. Fully adjust the tilt upward when inserting screws into the bottom to avoid the same problem with the bottom crossbar. To complete the installation of your new plasma mount, carefully place the television with attached arm brackets over the cross-bars on the wall plate (see Diagram C). Begin by placing the wall plate into position against the wall, using the bubble guide to keep it level. Mark off six holes to be used for securing the mount and place the wall plate aside. Next, drill holes using an electric drill and 5/16" (8mm) masonry bit. If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall. Once all of the anchors are in place, move the wall plate back into position. Screw a Drywall Screw (Q) and Drywall Washer (R) into each anchor (see Diagram A). [. . . ] This limited warranty only extends to the first original purchaser for 5 years . Insérer un petit cadenas (non fourni avec le produit) à travers les trous situés sur les blocages et sur les bras du support pour empêcher toute séparation du téléviseur de son support (schéma F). Pour terminer l'installation du support, poser délicatement le téléviseur (auquel les bras sont déjà fixés) sur les deux barres horizontales de la structure du support mural (schéma C). [. . . ]