User manual VISA VE-L30-T

[. . . ] Tools Required: Tape Measure & Pencil Phillips Head Screw driver Stud finder for drywall installation Socket and Wrench Electric drill and 10mm masonry bit for concrete/brick installation PLEASE NOTE: Study the following instructions and assembly diagrams with care prior to installing and using the mount. We do not accept any responsibility for failure to follow the instructions and limits of use and for any alterations made to the product. [. . . ] 7), insert only the UPPER screws avoiding to completely tighten them keeping the screws at around 3mm from the wall (see fig. 2) NOTE: this wall mount will be definitively fixed on the wall just after it is fixed on the TV/monitor screen. For WOOD walls: execute the above procedure (b) without making the holes for the anchors STEP 2 ­ Mounting the arm on the LCD rear panel Important: *) NEVER mount the wall mount ith the LCD/PLASMA screen plugged in and / or *) with the screen faced downwards (to avoid screen surface damages). Check the rear side of the LCD/Plasma screen: - if this surface is flat, mount the arm of wall mount without any spacer (see fig. 3); - otherwise choose the suitable spacers kit Warning: Avoid over-tightening the screws. STEP 3 ­ Final mounting To complete installation: carefully insert the wall mount support (with the LCD/Plasma screen mounted on it) such as the four slots in the wall mount basis are fit into the four screws before placed on the wall (see fog. 4); carefully move down the wall mount support till the screws placed on the wall reach the end strokes of corresponding slots (fig. Adjustment: The angle of vertical inclination ( Tilt ) can be adjusted by the grey knob placed behind where the LCD/Plasma screen is mounted. Unscrew the knob turning anticlockwise, adjust the inclination and tighten the knob to secure the new position. Other adjustments can be made with regard to vision by moving the arm into the desired position. [. . . ] This limited warranty only extends to the first original purchaser for 5 years . ETAPE 3 - Assemblage final Pour terminer l'installation: - insérer le support avec le moniteur LCD/PLASMA monté, faisant passer la tête des quatre boulons déjà fixé au mur , dans les quatre fentes appropriées, situées sur la base du support (voir fig. [. . . ]