User manual VISA BT302 I TECHNICAL DESCRIPTION

[. . . ] The installation instructions must be read to prevent personal injury and property damage. Keep these installation instructions in an easily accessible location for future reference. A secure structure must support the weight or load of the display, When mounting to a wall that contains wooden studs, dead center of the wooden stud must be confirmed prior to installation. [. . . ] A secure structure must support the weight or load of the display, When mounting to a wall that contains wooden studs, dead center of the wooden stud must be confirmed prior to installation. Do not install near heater, fireplace, direct sunlight, air conditioning or any other source of direct heat energy. Failure to do so may result in damage to the display and could increase the risk of fire. At least two qualified people should perform the installation procedure. Injury and/or damage can result from dropping or mishandling the display. If the mount is to be installed on any surface other than wooden studs, use suitable hardware (which is commercially available). Before installation, you need measure the horizontal distance of the holes on the back of the television you want to install and get the data. Use pencil to draw a horizontal line on the place you want to install your television, making sure the the line must be horizontal to the ground and at least as wide as the width of the horizontal hole distance on back of your TV. NOTE: Select the spacer that is closest in depth to the recess to keep your bracket as close to the display as possible. If a smaller screw is being used(M4, M5 or M6), please use a washer with each screw for added stability. Final Installation Attach each bracket to the display by aligning the holes on each bracket, with the threaded inserts on the back panel of your display, inserting the screws through both and turning clockwise until they are fully inserted. To complete the installation of your new lcd/plasma mount, carefully place the television brackets over the upper and lower mounting crossbars. Other feature of your display mount is the lock designed to prevent your television from being removed from the two wall plates. To use the security function, you only need to thread the screws under the TV brackets till it locked the bracket tightly. Operation and Adjustment You can adjust the tilt of your television by using the tension knob located on the right-hand side and left-hand side of the TV brackets. First, turn the tension knobs counter-clockwise to loosen the mounting crossbars. [. . . ] To use the security function, you only need to thread the screws under the TV brackets till it locked the bracket tightly. Operation and Adjustment You can adjust the tilt of your television by using the tension knob located on the right-hand side and left-hand side of the TV brackets. First, turn the tension knobs counter-clockwise to loosen the mounting crossbars. [. . . ]