User manual VDO DAYTON RCS 5100

[. . . ] Therefore, please observe this information with particular care. A IMPORTANT INFORMATION When driving straight ahead the Steering Wheel Remote Control must under no circumstances obstruct the drivers sight on the following pilot lights and controls: Pilot lights of turning indicator, high beam, rear fog lamp, fog lamp, brakes, Airbag, ABS, ESP and the speedometer. Use only the parts included with the unit to ensure proper installation. The use of unauthorised parts can cause malfunctions. A A Scope of delivery Before starting installation check scope of delivery. [. . . ] Close the locking lever (1. ) and then push it in the direction of the +/- buttons (2. ), (fig. If the locking lever should not engage, or the remote control should not fit firmly enough at the steering wheel, please repeat steps 3. If required cut the remaining part of the strap above the locking lever. Note: In order to improve adhesion in the case of steering wheels of large internal diameter, the foam rubber pad supplied with the unit can be bonded to the battery compartment lid of the remote control before installation. Controls Mode selection (only RCS 5100), fig. 5a The RCS 5100 is suitable for both audio components as well as Navigation Systems. Use the slide switch 3 at the outer side of the remote control to change the mode. Switch to "N" to be able to control Navigation Systems. Switch to "A" to be able to control Audio components. Note: With some Navigation Systems you have to activate the "Steering wheel remote control" option in the system settings menu to control the system with the Steering Wheel Remote Control. You find information on that in the instructions for use of the respective device. With some Navigation Systems the supplied remote control must be taken out of the holder so that the system reacts to the Steering Wheel Remote Control. Plan an alternative route Function Audio mode (A) Press briefly: MUTE. 4 and 6: Search (tuner), Next / previous Track (cassette, CD) 8 and 2: next / previous preset Mode switch Navigation / Audio OK: Sound menu (sound settings) Press briefly: SOURCE. Switching audio source Press longer: no function Decrease volume / set sound Increase volume / set sound 2 3 4 5 Cursor keys: Move the cursor in menus Mode switch Navigation / Audio OK : Confirming a selection. For systems with map display: Toggle between Menu and map display Press longer: MENU. Jump to main menu 6 7 Decrease volume Increase volume RCS 4000, fig. 5b Key 1 2 3 4 5 6 NAVI: Changeover to navigation Cursor keys: Move the cursor in menus OK: Confirm to a selection SOURCE: Changeover to audio, select audio source Decrease volume Increase volume Function Replacing battery of the remote control, fig. 4 In order to ensure proper functioning of the steering wheel remote control in the vehicle, it is essential that only CR 2 type batteries are used, which are heat-resistant up to 100 °C according to the battery manufacturer's specifications. You have to replace the battery of the remote control, if the device to be controlled no longer responds to key presses even under favourable circumstances or the device to be controlled indicates a weak battery. A Remove the remote control from the steering wheel. For this purpose first push the locking lever towards the +/­ buttons and then lift it. [. . . ] · Remove remote control of the Navigation System from its holder. · Activate "Steering Wheel Remote Control" option in the System Settings menu of your Navigation System. Navigation mode selected: · Set Mode switch on the Remote Control to "A". After the first press on OK the system does no longer react on the Steering Wheel Remote Control. [. . . ]