User manual VDO DAYTON PN 4000 TSN QUICK START GUIDE

[. . . ] The supplier of this system does not accept any liability whatsoever for the availability and accuracy of GPS data. WEEE compliance All electrical and electronic equipment must be disposed of separately from general household waste using the sites designated by local authorities. If a product displays this symbol of a crossed-out rubbish bin, the product is subject to European Directive 2002/96/EC. The appropriate disposal and separate collection of used equipment serve to prevent potential harm to the environment and to health. [. . . ] Damaged batteries or batteries that are past their expiry date should no longer be used and should be disposed of in a safe and suitable way. Installation · · Before attaching the cradle to the front windscreen, you should clean the area on the windscreen to remove grease and dust. Differences between daytime and nighttime temperatures and/or humidity and moisture can break the vacuum seal under the suction cup of the cradle. You should therefore attach the navigation system so that it will not be damaged if it falls off the windscreen. As a precautionary measure, you should detach the navigation system at night. Please do not use any cleaning agents or detergents to clean the screen and case of the device. Nor should the device be attached within the area in which the airbags open or within reach of the head or knees in the event of a collision. Secure the device so that it will not slide around in the event of emergency braking or a collision. · 12 PN 4000/6000 To install the device in the vehicle, proceed as follows: · Find a suitable place in the vehicle for attaching the cradle. The screen should be clearly visible from the driver's seat but the device should not obscure the driver's view. · Press the suction cup against the glass (with a clear view of the sky) and move the pressure lever towards the glass until it locks in place. Detaching: To detach the device, move the pressure lever to the opposite direction and carefully pull the transparent rubber end of the suction cup to remove it from the windscreen. For safety reasons you should install the device and enter the required information in the system before you start your journey or when your vehicle is stationary. The use of the navigation system does not under any circumstances release the driver from their personal responsibility. The applicable road traffic regulations and current traffic conditions always have priority. The information provided by the device is for orientation purposes only and is not binding. Always check the information provided by the device (speed, remaining travelling time, distance, recommended route). If you need to look at the screen for a longer period of time, stop the vehicle at an appropriate and safe place. The touchscreen must not be operated with sharp or rough-edged objects as these can damage it. If you leave the vehicle for long periods you should take the navigation system with you to avoid theft. GPS reception When you switch on the device for the first time, it can take several minutes for the GPS reception to reach a sufficient level and to determine your current position. If you are using the navigation system in an inner-city area, it may take longer to refresh the map details. PN 4000/6000 Navigation · · · After switching on the navigation system, the legal disclaimer screen appears. As soon as the system is ready, the Main menu will appear on the screen. 13 Main menu Tap on Settings > Regional. · · · · · · Language: select your preferred language for the menu and map display. Tap the Back button in the top left corner of the screen to exit from a sub-menu without saving changes. [. . . ] The two antennae must be positioned at least 50 cm apart to enable reception. DVB-T picture reception switches off at speeds greater than 7 km/h unless the VDO Dayton back seat cradle is used. DVB-T sound reception and navigational information continue to be available. To switch on the television, tap the DVBT button in the Multimedia menu. The television screen will be displayed with the buttons for operating the television receiver. Scanning for and selecting a channel Call up the scanning and channel selection functions by tapping the Channels bar at the top of the screen. [. . . ]