User manual US ROBOTICS 56K USB MODEM QUICK GUIDE

[. . . ] WAR N I NG The phone socket you use must be for an A N ALO G UE phone line. Plug the power supply into the jack on the modem and the other end into an electrical outlet. NOT NOT E : If the power light does not illuminate, the modem may not be turned on. Make sure the power supply is connected between the modem and the electrical outlet. [. . . ] In the Modems Properties screen, you should see a description for your modem. If your modem is not listed and/or you do not see a series of commands and responses, check that all connectors and power cables are properly connected to your modem and the back of your computer. check that the modem is switched on and the CS or the PWR light is illuminated. Your communications software may not function properly if you have more than one version of the software installed, you are using an older version, or you have more than one communications software package installed on your system. We highly recommend using the communications software provided with your modem on the Installation CD-ROM. There should be a place in the Setup section of your software that addresses port settings. Make sure the software's port settings match those for your modem. Check your communication software's documentation for instructions on adjusting the port settings in your software. PROB OBL My PROBLE M: My modem won't dial out or doesn't answer incoming calls. FOR BOTH DIALI LING AN ANSWE PROB OBL FO R BOTH DIALI NG AN D AN SWE R I NG PROBLE MS: You may have a bad phone cord connection to your modem, or your phone cord may be plugged into the wrong jack. The phone cord should be plugged into the jack on the modem and into the wall phone jack. EN60950 EN55022 EN55024 EN61000-3-2 EN61000-3-3 We hereby declare that the above named product is in conformity with the essential requirements and other relevant provisions of Directive 1999/5/EC. This equipment is supplied with a suitable PSTN connector for the country in which it was supplied. If it is required to use this equipment on a different network to the one for which it was supplied, the user is advised to contact the vendor for guidance regarding connection. Please contact our support center for an RMA number before sending your product to the repair address. Product sent to the repair address without an RMA number will be returned unopened. 4 GENERAL TERMS: This Limited Warranty is extended only to the original end-user purchaser (CUSTOMER) and is not transferable. This Limited Warranty expressly excludes any product that has not been purchased as new from U. This Limited Warranty is only applicable in the country or territory where the product is intended for use (As indicated by the Product Model Number and any local telecommunication approval stickers affixed to the product). ROBOTICS warrants to the CUSTOMER that this product will be free from defects in workmanship and materials, under normal use and service, for TWO (2) YEARS from the date of purchase from U. ROBOTICS sole discretion, to repair the defective product or part with new or reconditioned parts; or to exchange the defective product or part with a new or reconditioned product or part that is the same or similar; or if neither of the two foregoing options is reasonably available, U. ROBOTICS may, at its sole discretion, provide a refund to the CUSTOMER not to exceed the latest published U. [. . . ] ROBOTICS Service Centre determines the product or part has a malfunction or failure attributable directly to faulty workmanship and/or materials; and the product is within the TWO (2) YEAR warranty term; and the CUSTOMER will include a copy of the dated Proof of Purchase (original purchase receipt from U. ROBOTICS or its authorised reseller) with the product or part with the returned product or part, then U. CUSTOMER agrees to pay shipping charges to return the product or part to the authorised U. ROBOTICS Return Centre; to insure the product or assume the risk of loss or damage which may occur in transit; and to use a shipping container equivalent to the original packaging. [. . . ]