User manual US ROBOTICS 56K MESSAGE MODEM QUICK INSTALLATION GUIDE FOR WINDOWS

[. . . ] No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as a translation, transformation, or adaptation) without written permission from U. Robotics Corporation reserves the right to revise this documentation and to make changes in the products and/or content of this document from time to time without obligation to provide notification of such revision or change. Robotics Corporation provides this documentation without warranty of any kind, either implied or expressed, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. If there is any software on removable media described in this documentation, it is furnished under a license agreement included with the product as a separate document, in the hard copy documentation, or on the removable media in a directory file named LICENSE. [. . . ] If your modem is still not working, refer to the additional troubleshooting in this Guide. NOTE: If your modem is not listed and/or you do not see a series of commands and responses, make sure that your cables are attached correctly to your computer. If your modem still does not work, refer to the additional troubleshooting in this Guide. To verify that your modem is functioning properly, repeat the steps listed under your specific operating system. For additional troubleshooting help, review these common issues: PROBLEM: My computer isn't recognizing my modem. Possible solution: You may be using a COM port that is either already in use or not configured correctly. For the modem to work properly, it must be plugged into an enabled serial port which is assigned to a free COM port. most computers have two serial ports assigned to COM 1 and COM 2 respectively. Windows XP, 2000 Make sure your COM port is not already in use by another modem. If a previous modem is already using the available COM port, you can either use another COM port or uninstall the modem that was installed previously. see your previous modem's manual for uninstallation instructions. If the Communications ports have yellow exclamation points or red Xs over them, your COM ports may be configured incorrectly. If this is the case, you may need to contact your computer manufacturer. It is also possible that you may be plugging your external Refer to your computer's manual for information about enabling COM ports. This usually involves altering the BIOS settings and possibly the operating system. You may need to call your computer's manufacturer to change your BIOS settings if they are incorrect. Windows Me, 98, 95 Make sure your COM port is not already in use by another modem. click Start , Settings , and Control Panel , and then double-click Modems. If you have Windows Me and you do not see this icon, be sure to select View All Control Panel Options. Look for another modem listed and if another modem is listed, click the Diagnostics tab to find out which COM port it is using. If a previous modem is already using the available COM port, you can either use another COM port or uninstall the previously installed modem. see your previous modem's manual for uninstallation instructions. [. . . ] Robotics modems can also be answered by technical support specialists. Robotics Corporation of 935 National Parkway, Schaumburg, Illinois, 60173-5157 USA, declare under our sole responsibility that the product, 56K Message Modem, Model 5668, to which this declaration relates, is in conformity with the following standards and/or other normative documents. EN61000-3-3: 1995 We hereby declare that the above named product is in conformity with the essential requirements and other relevant provisions of Directive 1999/5/EC. This equipment is supplied with a suitable PSTN connector for the country in which it was supplied. [. . . ]