User manual US ROBOTICS 56K FAXMODEM USB INSTALLATION GUIDE FOR WINDOWS REV 1.1

[. . . ] No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation, or adaptation) without written permission from U. Robotics Corporation reserves the right to revise this documentation and to make changes in the products and/or content of this document from time to time without obligation to provide notification of such revision or change. Robotics Corporation provides this documentation without warranty of any kind, either implied or expressed, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. If there is any software on removable media described in this documentation, it is furnished under a license agreement included with the product as a separate document, in the hard copy documentation, or on the removable media in a directory file named LICENSE. [. . . ] To ensure USB is enabled on your system in Windows 98 or Me, click Windows Start, Settings, and then Control Panel. To ensure USB is enabled on your system in Windows 2000, click Windows Start, Settings, and then Control Panel. doubleclick the Systems icon , click the Hardware tab , and then click the Device Manager button. All Windows users, if USB is enabled, there will be a USB icon and the words "Universal serial bus controller" under the Computer icon. If USB is not enabled, you will need to enable USB in the system's BIOS. check with your computer manufacturer's documentation for instructions. Once your USB port has been enabled in your system's BIOS, Windows will automatically detect and install USB support when it restarts. Possible solution: Your communications software may not function properly if you have more than one version of the software installed, you are using an older version, or you have more than one communications software package installed on your system. We highly recommend using the communications software provided with your modem on the Installation CD-ROM. Possible solution: You may not have the correct modem type selected in your software or in Windows. When Control Panel opens, click Phone and Modems and then click the Modem tab. You can also add, remove, or view the properties of modems from this window. Robotics modem you have installed should be present in the list of installed modems. Robotics modem or no modems are listed, your modem is not installed properly. Possible solution: If you are using Dial-Up Networking, it may not be configured correctly. Check your configuration and make sure you have the correct modem selected. Double-click My Computer, double-click Dial-Up Networking, right-click the connection you are trying to use, and click Properties. Make sure that the description in the modem box matches the description of the modem you are using. PROBLEM: My modem won't dial out or doesn't answer incoming calls. FOR BOTH DIALING AND ANSWERING PROBLEMS: Possible solution: You may have a bad phone cord connection to your modem, or your phone cord may be plugged into the wrong jack. The phone cord should be plugged into the jack labeled TELCO on the modem and into the wall phone jack. OFFICE USERS: Possible solution: You may have plugged your modem's phone cord into a digital line. [. . . ] 2 CUSTOMER is specifically advised to make a backup copy of all software provided with this product. 3 CUSTOMER assumes full responsibility to properly install and configure this product and to ensure proper installation, configuration, operation and compatibility with the operating environment in which this product is to function. ROBOTICS or its authorised reseller) for any warranty claims to be authorised. ROBOTICS Service Centre within the applicable warranty period to obtain warranty service authorisation. [. . . ]