User manual TRIMBLE SPS RELEASE NOTES V4.17 REV A 8-2010

[. . . ] RELEASE NOTES Trimble SPS Series Receivers ® Introduction New features and changes since version 4. 15 Version 4. 17 Revision A August 2010 F Corporate office Trimble Navigation Limited Engineering and Construction group 5475 Kellenburger Road Dayton, Ohio 45424-1099 USA 800-538-7800 (toll free in USA) +1-937-245-5600 Phone +1-937-233-9004 Fax www. trimble. com Copyright and trademarks © 2010, Trimble Navigation Limited. Trimble and the Globe & Triangle logo are trademarks of Trimble Navigation Limited, registered in the United States and in other countries. Trimble Survey Controller and VRS are trademarks of Trimble Navigation Limited. [. . . ] In both cases ensure, that the receiver warranty date is September 2009 or later. Then: · If using the WinFlash utility, use the latest version that is available with the version 4. 17 web package. If using the receiver web interface to load the *. TIMG file, ensure that the receiver is already running version 3. 71 or later before stating this installation. Note ­ If you have a receiver with firmware earlier than version 3. 60, first load version 3. 60 and then load version 3. 71 before loading version 4. 17. If required, contact your Trimble dealer to obtain version 3. 60. · SPS Series Receivers Release Notes 3 If your Trimble receiver is supplied with additional Trimble firmware or software products, make sure that those products are upgraded to the latest version. For more information about upgrading, refer to the release notes for the products. Use the following table to verify if you need to update the firmware for your receivers: Product/Feature SPSx52 SPSx51 SPSx81/SPS882 SPSx61 Trimble Survey ControllerTM software SCS900 software OmniSTAR Beacon VRSTM system IBSS (Internet Base Station Service) support Marine OEM Integrator Firmware upgrade?Recommended Recommended Not required Suggested Not required Not required Recommended Recommended Not required Recommended Not required Not required 1. 2 New features and changes since version 4. 15 SPS Modular GNSS receivers only · 12. 1 The IBSS connection now restarts on a base station if any of the reference station information changes. If any Internet Base Station (IBS) details change in the receiver while an existing connection to the IBSS exists, the receiver automatically restarts the IBSS connection to ensure the changes are kept current. 4 SPS Series Receivers Release Notes · The SNM910 cellular modem now supports a wider range of SIM cards from GPRS service providers, resolving the issue of the cellular modem not readily making an Internet connection when using some SIM cards. The receiver now correctly deregisters itself from the list of discovered devices when it is turned off. Receivers now no longer randomly go into PC Loader or Remote Monitor mode. When an application file is started, a selected user-defined 450 MHz transmit frequency is now retained as the selected frequency in the application file. SPSx61 Repeat RTCM output is now compatible with Kongsberg Seapath Series systems. Kongsberg Seapath Series systems can now decode and use the Repeat RTCM output, which is generated from the internal MSK Beacon receiver. [. . . ] When the Report extended information in NMEA GGA and RMC strings field is cleared, the NMEA RMC message is now NMEA compliant. This message provides local grid position and position quality indicator. Before this message type can be used, ensure that there is a coordinate system loaded in the receiver. · 6 SPS Series Receivers Release Notes [. . . ]