User manual TRIMBLE S6 R12.2.40 RELEASE NOTES

[. . . ] Trimble S6 Total Station Firmware R12. 2. 40 Release Notes Trimble S6 Total Station Firmware R12. 2. 40 Release Notes Note: Please refer to the Trimble® S6TM Total Station User Manual for legal information. Introduction These release notes contain information about the Trimble S6 Total Station firmware version R12. 2. 40. In a newly purchased instrument, Trimble S6 Total Station firmware version R12. 2. 40 should already be installed from the factory. [. . . ] Connect a hirose 6-pin to PC USB cable (part number 73840001 or 738140019) from the instrument foot connector labeled COM to a USB port on the office computer. Ensure that the Trimble CU / Trimble TSC2 controller is removed and that you have a fully charged battery in the instrument. Run the file Trimble S6 Total Station Firmware R12. 2. 40. exe that you saved on the office computer to begin the firmware upgrade. Follow the instructions in the installation wizard to complete the upgrade. Using the Trimble S6 Total Station with other Trimble Products Trimble S6 Total Station firmware version R12. 2. 40 is compatible with the following Trimble survey field software. Page 1 of 2 Trimble S6 Total Station Firmware R12. 2. 40 Release Notes Trimble Access version 1. 4. 0 or later on the Trimble CU and Trimble TSC2. Trimble Survey Controller version 12. 00 or later on the Trimble CU and Trimble TSC2. Trimble® Survey ManagerTM software Field and Tablet PC version 2. 40 or later. Please check the release notes for the respective Trimble survey field software for more product information including operating system and Trimble office software requirements. IMPORTANT: This version of Trimble S6 Total Station firmware is not compatible with versions of Trimble survey field software older than those listed above. Similarly, these versions of Trimble survey field software are not compatible with versions of the Trimble S6 Total Station firmware older than R5. 1. 6. Please take note of the following information before upgrading your Trimble S6 Total Station. [. . . ] Trimble always recommends that customers regularly check www. trimble. com for the latest versions of software and firmware for all of their Trimble products. New Features / Enhancements The Trimble S6 Total Station firmware version R12. 2. 40 includes the following new features and enhancements: Improvements in the "Semi-active" prism mode for the Trimble MultiTrack target in Trimble Access version 1. 4. 0 and later and Trimble Survey Controller 12. 46 and later. Improvements to the tracker and servo system which provide enhanced tracking and searching to passive targets. Page 2 of 2 [. . . ]