User manual TRIMBLE EZ-GUIDE 500 LIGHTBAR QUICK REFERENCE CARD WITH AGGPS AUTOPILOT SYSTEM

[. . . ] EZ-Guide® 500 Lightbar with the AgGPS® AutopilotTM System Quick Reference Card CONNECTING THE SYSTEM When the AgGPS® AutopilotTM system has been professionally installed, add the EZ-Guide® 500 lightbar guidance system as shown: Antenna EZ-Guide 500 lightbar Antenna cable SiteNet radio antenna magnetic mount (P/N 62109) Antenna connector (ZTN 46740) SiteNet radio External keypad (ZTN 66030-00) EZ-Guide 500-to-Autopilot cable (ZTN 62063) External interface cable (ZTN 52033) EZ-Guide 500-to-radio cable (ZTN 62082) LABEL SiteNetTM radio antenna (P/N 22882-00) Autopilot NavController II (P3-GPS connector) (Optional) LIGHTBAR LAYOUT Offline guidance LEDs Function buttons These buttons perform the functions indicated by the icons. When the vehicle is online, the center three green LEDs are lit. When it is offline, the lit LEDs move to the side. ESC button (back of unit) Cancels changes and moves up one menu level. Buttons: OK, Up, Down Swath lines The current swath is red. [. . . ] The warning requires you to acknowledge it to remain in normal automatic mode. This warning appears when you are at the specified distance from the end of the current row. This can be helpful if the operator is likely to be distracted (for example, by monitoring other equipment during operation). You can enable or disable NMEA message output from the Autopilot controller laptop port. If NMEA messages are enabled, you can configure which formats are output and the baud rate. Note -- Ensure that the baud rate you select is the same as that of the device that is receiving the messages. You can save or restore a custom system configuration file from the Autopilot controller. To download a file, you are required to enter a name for the file. End of Row Warning Distance NMEA Output Download / Upload Custom Configuration File www. AutopilotGPS. com EZ-Guide® 500 Lightbar with the AgGPS® AutopilotTM System Quick Reference Card ADVANCED MODE APPLICATION USE Reset guidance Select the press o. Create New Field / Add AB Line icon and then Select Stored Field / Select AB Line Confirm or change settings Select field and AB line Confirm or change field name Select event option Map the AB line Get guidance www. AutopilotGPS. com EZ-Guide® 500 Lightbar with the AgGPS® AutopilotTM System Quick Reference Card ENGAGING To engage the EZ-Guide 500 system with the AgGPS Autopilot system, you must have a line defined and the vehicle must be within the engage limits of the system. Do one of the following: ­ ­ ­ Press the engage button Press the engage button on the main guidance screen. on the optional remote control. Press the optional remote engage foot pedal. DISENGAGING The system automatically disengages when: · The vehicle is outside the engage limits · GPS positions are lost · The Minimum Fix Quality setting is set to a high accuracy correction method (for the AgGPS Autopilot system, this is usually RTK Fixed) and the system receives low accuracy positions (for example, no corrections). [. . . ] · To clear a message bar warning, press the top function button (to the left of the screen). © 2007. Trimble, the Globe and Triangle logo, AgGPS, EZ-Guide, and EZ-Steer are trademarks of Trimble Navigation Limited, registered in the United States and in other countries. [. . . ]