User manual THUNDER TIGER PHOENIX ST BX

[. . . ] Do not operate model products in rain, on public roads, near crowds, near airport, or near areas with restricted radio operation. This product, its parts, and its construction tools can be harmful to your health. Always exercise extreme caution when assembling and/or operating this product. [. . . ] When there is a radio glitch, it will most likely be caused by improper crystal, damaged crystal, or people operating on the same frequency. 4 INSTALLING THE BATTERY PACK (Battery products are not included in kit) a b a. Install the power pack (Flat type battery pack shown in the picture) and connect to the ESC. Caution: Check all the wiring and connections before you connect the speed control to a drive battery. Incorrect polarity will wreck your speed control. 5 RADIO OPERATION a b c a. When turning off, first turn the receiver off, then the transmitter off. To reverse the functions of servos, use the small, white servo reverse switches located on side of the pistol transmitter (or the inset servo reverse switches located at the bottom of the stick transmitter). To trim the servos on pistol transmitter, use the trim switches on side of the steering wheel (the ST. On a stick transmitter, the trim levers are located accordingly around the sticks. Do not run flat the battery of your transmitter in case of losing control of the car. For more details, please check the transmitter instruction manual. d. With the radio transmitter and receiver on, turn the steering wheel/stick to the left. The front tires/wheels should turn right accordingly. 7 ADJUSTING ELECTRIC SPEED CONTROL (ESC) a b c d e f a. f. Make sure the motor is disconnected or ensure some other way that the wheels are free to rotate. Hold the set-up button pressed in for at least 3 seconds using the plastic tuning wand supplied. 7 ADJUSTING ELECTRIC SPEED CONTROL (ESC) (Picture shows the Ace R/C "Veloci-RS" electric speed control pre-installing on PHOENIX Ready-To-Run version). [. . . ] Discharging the battery pack by running the electric motor until it slows down or using a discharger (Not included). b. Heat may prevent the battery pack from charging to full capacity and also decreases the performance of the battery. c. Once the battery ready to be charged, first plug the AC quick charger into the outlet of AC power source, and then connect the battery input/output harness to the charger. d. [. . . ]