User manual TASCO TRAIL CAMERA 119213C

[. . . ] Install 4 "D" cell batteries (flat base of all batteries contacting springs), and insert an SD card (not included, use any capacity up to 8GB) in the slot to the right of the 5 buttons (upside down, brand name facing you). If you are using the camera for the first time, you should set the date and time so your photos will be "stamped" correctly. briefly press the Menu button-the "year" digits will blink on the display. Use the Up/Down buttons to set the current year, then press Enter, and repeat to set the month and press Enter again. [. . . ] Install 4 "D" cell batteries (flat base of all batteries contacting springs), and insert an SD card (not included, use any capacity from 16MB to 8GB. ) in the slot to the right of the 5 buttons as indicated on the slot cover (upside down, with the notched corner of the card on the left and metal contacts of the card facing the back of the slot). If the Cam is turned on without a card in place, it may not turn off-reset it by pulling one of the batteries out partway, insert a new or empty SD card, and put the battery back in place. If you are using the camera for the first time, you should set the date and time so your photos will be "stamped" correctly. Briefly press the Menu buttonthe first two digits of the year will flash, prompting you to enter the year (a). The display will then change to let you set the day, with only the last two digits blinking (b). Again use the Up/Down buttons to change the day if necessary and press ENTER. By pressing UP/DOWN, the camera will cycle between Lo resolution still photo, Hi resolution still photo, and movie (video) modes. The "Lo" setting will allow you to take lower resolution images and therefore Accumulate more images on your card while the "HI" setting will give you high resolution images of better quality but fewer images can be stored to the card. In Movie mode a 14 second AVI file will be recorded to the SD Card each time the camera is triggered. Formatting is recommended before you re-use an old SD card, and is a quick way to erase all of the photos/videos after you've saved any d you wish to keep. The display will read "FoNo", with "No" and the SD card icon blinking (d). Press ENTER when "No" is flashing if you don't want to format the card. To format the card, press either UP/DOWN button and the "Fo" portion will blink. Press ENTER and the display will change to "Y N" with the SD card icon blinking. "N" (NO) is the default, so pressing ENTER will cancel the formatting, then pressing and holding MENU will exit menu mode. If you are certain that you want to format the card and DELETE all data and images on the card, then press either UP/DOWN button to select "Y" (YES). with "Y" flashing , press ENTER- the display will briefly change to "SdFr". After the card has been formatted, the camera will exit the MENU mode and is ready to take images. Press and hold MENU to exit Menu mode at any time once you have finished changing any of the menu item settings or using one of the menu options. In normal operating mode, the display will only show the still photo or movie clip icon in the lower left corner, an SD card icon on the lower right, and one or more digits that indicate how many photo or movie files have been stored on the card. To test the camera operation, wave your hand in front of the lens and PIR (passive infrared/motion) detector, while looking at the LCD display. [. . . ] The camera's field of view is a 45 degree cone, centered on the PIR detection zone. This product is warranted against original defects in material and/or workmanship for the length of time specified by this warranty, provided, however, that the unit has not been abused, taken apart or tampered with in any way whatsoever. This warranty is limited to the original purchaser and is not transferable. This warranty applies only to products purchased in the United States of America. [. . . ]