User manual SONY VAIO VPC-CA17FX/B

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SONY VAIO VPC-CA17FX/B. We hope that this SONY VAIO VPC-CA17FX/B user guide will be useful to you.


SONY VAIO VPC-CA17FX/B : Download the complete user guide (2713 Ko)

You may also download the following manuals related to this product:

   SONY VAIO VPC-CA17FX/B QUICK START GUIDE (1408 ko)
   SONY VAIO VPC-CA17FX/B QUICK START GUIDE (1408 ko)
   SONY VAIO VPC-CA17FX/B HARD DISK REPLACEMENT INSTRUCTIONS (450 ko)
   SONY VAIO VPC-CA17FX/B RECOVERY, BACKUP AND TROUBLESHOOTING GUIDE (483 ko)
   SONY VAIO VPC-CA17FX/B OPTICAL DISK DRIVE REPLACEMENT INSTRUCTIONS (443 ko)

Manual abstract: user guide SONY VAIO VPC-CA17FX/B

Detailed instructions for use are in the User's Guide.

[. . . ] PCMCIA is a trademark of the Personal Computer Memory Card International Association. PowerQuest and Drive Image are registered trademarks of PowerQuest Corporation. Netscape is a registered trademark of Netscape Communications Corporation. McAfee is a registered trademark of Network Associates/ McAfee. com, Inc. [. . . ] If the spots are numerous or large enough to interfere with your operation needs. The application display uses only a portion of your screen and is surrounded by a dark frame. You are running an application that does not support 800 x 600/1024 x 768 pixel resolution display and display compression is enabled. This is normal; do nothing. Display is faulty; contact your support representative. Display compression gives a clearer but smaller display for applications that do not support 800 x 600/1024 x 768 pixel resolution. You can fill the screen but have less resolution by changing your display compression setting, (See the Video Features submenu, located within the Advanced menu of the BIOS. Press [Fn] + [F7] to increase brightness or doubleclick on BatteryAid battery gauge and adjust Power Control under battery settings. The Display is dark when on battery power. The BatteryAid default is set on low brightness to conserve power. 58 B Series. book Page 59 Thursday, April 11, 2002 4:34 PM Tro ubleshoo ting Problem Possible Cause Possible Solutions You have connected an external monitor and it does not display any information. Your BIOS setup is not set to enable your external monitor. Try toggling the video destination by pressing [Fn] and [F10] together, or check your BIOS setup and enable your external monitor. (See the Video Features submenu, located within the Advanced Menu of the BIOS. Check your device and operating system documentation and activate the proper driver. Your external monitor is not properly installed. Your operating system software is not setup with the correct software driver for that device. Miscellaneous Problems An error message is displayed on the screen during the operation of an application. Your external monitor is not compatible with your notebook. See your monitor documentation and the External Monitor Support portions of the Specifications section. In the unlikely case that you see this message you may have some display problems. You can continue operating but should contact your support representative for more information. You may have to replace your keyboard or keyboard controller but may be able to use an external keyboard until then. You may have to replace your keyboard or keyboard controller but may be able to use an external keyboard until then. *Keyboard error nn BIOS discovered a stuck key and displays the scan code for the stuck key. You may have to replace your keyboard but may be able to use an external keyboard until then. *Monitor type does not match CMOS ­ Run SETUP Monitor type not correctly identified in Setup. This error probably means your BIOS is corrupted, run the setup utility and set all settings to the default conditions. *Operating system not found Operating system cannot be located on either drive A: or drive C: Enter the setup utility and see if both the fixed disk, and drive A: are properly identified and that the boot sequence is set correctly. Unless you have changed your installation greatly, the operating system should be on drive C:. If the setup utility is correctly set, your hard drive may be corrupted and your system may have to be re-installed from your back up media. [. . . ] Shut down Windows, and turn off the computer. 106 B Series. book Page 107 Thursday, April 11, 2002 4:34 PM W I r e l e s s L A N U s e r 's G u id e Problem I want to remove the driver (Windows 2000) Possible Cause Possible Solution Windows 2000: When removing the driver, make sure that the device is attached to the computer. If you try to remove the driver while the device is detached from the computer, the driver is not removed. Right click the [My Computer] icon on the desktop, and then click [Properties] from the menu that appears. Right click [Intersil PRISM Wireless LAN PCI Card], and click [Uninstall] from the menu that is displayed. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SONY VAIO VPC-CA17FX/B




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SONY VAIO VPC-CA17FX/B will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.