User manual SONY VAIO VGN-FW590GJB

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SONY VAIO VGN-FW590GJB. We hope that this SONY VAIO VGN-FW590GJB user guide will be useful to you.


SONY VAIO VGN-FW590GJB : Download the complete user guide (2593 Ko)

You may also download the following manuals related to this product:

   SONY VAIO VGN-FW590GJB QUICK START GUIDE (1270 ko)
   SONY VAIO VGN-FW590GJB DATASHEET (504 ko)
   SONY VAIO VGN-FW590GJB QUICK START GUIDE (1270 ko)

Manual abstract: user guide SONY VAIO VGN-FW590GJB

Detailed instructions for use are in the User's Guide.

[. . . ] SONY may make improvements or changes in the products or the programs described in this publication at any time. Requests for technical information about SONY products should be made to your SONY Authorized Dealer or your SONY Marketing Representative. Note to US Government Users -- Documentation related to restricted rights -- Use, duplication, or disclosure is subject to restrictions set forth in GSA ADP Schedule Contract with SONY Corp. Preface About this manual This manual contains service and reference information for SONY ThinkPad R30/R31 products. Use this manual along with the advanced diagnostic tests to troubleshoot problems effectively. [. . . ] May require setting legal date (1991­2099). 0251 Enter Setup to configure the system. If the error persists, check the system battery. 0270 Real time clock error The mainboard may need the system date and time. Enter Setup to reconfigure the system date and time. 0271 Check date and time settings MT 2656, 2657, 2676 41 Error Code 0280 Message Previous boot incompleteDefault configuration used Meanings Previous POST did not complete successfully. If the failure was caused by incorrect values and they are not corrected, the next boot will likely fail. On system with control of wait states, improper Setup settings can also teminate POST and cause this error on the next boot. CHeck to see that the drive is defined with the proper diskette type in Setup and that the diskette drive is attached corretly. EEPROM checksum is not correct (block #0, 1). EEPROM CRC2 is not correct (block #6). EEPROM checksum is not correct (block #4, 5). Comment SONY customized not to display this message. 041 043 Floppy drive Aerror Floppy drive B error Check Floppy drive is attached correctly. Enter Setup to check the type of floppy drive is correct (1. 44MB 3. 5, for example). 0175 Bad CRC1, stop POST task Invalid RFID Serialization Information Area or Bad CRC2 Replace planar. 0188 Replace planar. Box serial number needs to be reinstalled. 0189 Invalid RFID Configuration Information Area Replace planar. UUID needs to be reinstalled. 42 ThinkPad R30/R31 HMM Error Code 0193 Message Meanings Comment RFID model only. RF antenna had RFID antenna been removed has been removed, which was once installed. PC Card (PCMCIA) holder assembly 46 ThinkPad R30/R31 HMM Power Management-Related Symptoms Symptom/Error The system doesn't enter hibernation mode. FRU/Action in Sequence v Go to "Hibernation mode" on page 29. v Boot an operating system and press Fn+F12 and see if the computer enters hibernation mode. v Keyboard v Hard disk drive connector v Hard disk drive v System board The system doesn't resume from hibernation mode. v Hard disk drive connector v Hard disk drive v System board The system doesn't enter into or resume from sleep mode after closing the LCD. v Lid switch v System board v Lid close action in the power operation properties of the OS v Enter BIOS Utility and execute Load Setup Default Settings; then reboot the system. v System board System configuration does not match the installed devices. Peripheral-Device-Related Symptoms Symptom/Error External display does not work correctly. v Printer driver v Printer cable v Ensure that Parallel Port in the Config sub-menu menu of the BIOS Utility is correctly set. v System board MT 2656, 2657, 2676 47 Symptom/Error Parallel port device problems. FRU/Action in Sequence v Device driver v Device cable v Device v Ensure that Parallel Port in the Config sub-menu menu of the BIOS Utility is correctly set. v System board Modem-Related Symptom Symptom/Error Internal modem does not work correctly FRU/Action in Sequence v Go to "FRU tests" on page 54. v Modem connector v Modem board v System board Operating System-Related Symptom Symptom/Error Operating system not found FRU/Action in Sequence v Check that the operating system has no failure and is installed correctly. [. . . ] 1 2 Description 13. 3 LCD Bezel LCD Panel Asm (13. 3 TFT) 11P8212 Tori-Sanyo 11P8220 LG 3 4 13. 3 Hinge-Bracket Asm (R, L) LCD-Invertor / LED card (for 13. 3 & 14. 1 TFT) LCD-Invertor / LED card --Sumida (for 13. 3 & 14. 1 TFT) 5 6 LCD cable Asm. Antenna Kit 13. 3 LCD Antenna w/ 13. 3 LCD Antenna aux 26P9720 26P8139 26P8153 27L0687 26P9712 FRU No. 7 Description LCD Rear Cover Asm for 13. 3/14. 1 ( for Wireless model ) 13. 3/14. 1 LCD rear cover 13. 3/14. 1 LCDPanel W/Wireless SONY Logo LCD Rear Cover Asm for 13. 3/14. 1 13. 3/14. 1 LCD rear cover 13. 3/14. 1 LCDPanel W/O Wireless SONY Logo FRU No. 26P9709 26P9707 8 LCD Hinge Cap LG/SONY Logo Kit for LCD Rear Cover for KBD Bezel 26P9722 08K5860 14. 1-inch TFT: 1 3 2 3 4 6 5 7 8 No. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SONY VAIO VGN-FW590GJB




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SONY VAIO VGN-FW590GJB will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.