User manual SONY MHC-610

[. . . ] Do not, under any circumstances, place the CD player/stereo cassette deck on top of the A/V control amplifier. Do the following procedure 1 to 6 to hook up your system using the supplied cords and accessories. If you set up the stereo system vertically Be sure to place the A/V control amplifier on top of the CD player/stereo cassette deck. When you stand within 30 cm from the panel, the panel slides down automatically. [. . . ] ) · Dolby NR and DIRECTION MODE (ß or RELAY) is off when the mains AC power supply is switched off. With the side you want to play/record facing forward Select ß (or RELAY) to record on both sides. If you record from the reverse side, recording stops at the end of the reverse side. If you set DIRECTION MODE to ß when the tapes you use have different lengths, the tape in each deck reverses independently. You don't have to set DOLBY NR, since the tape in deck B is automatically recorded in the same state as the tape in deck A. Dolby NR and DIRECTION MODE (ß or RELAY) is off when the mains AC power supply is switched off. You can check the remaining time of the current track or that of the CD. This function lets you repeat a single CD or all CDs in normal play, Shuffle Play and Program Play. Each time you press the button during normal playback, the display changes as follows: N Playing time on the current track µ Remaining time on the current track µ Remaining time on current CD (1 DISC mode) or "PLAY" display (ALL DISCS mode) µ Clock display (for eight seconds) µ Effect (P FILE) name or "EFFECT ON (OFF)" µ Name of spectrum analyzer display pattern. To repeat All the tracks on the current CD All the tracks on all CDs Only one track Press PLAY MODE repeatedly until "1 DISC" appears in the display. pLAY MODE repeatedly until "ALL DISCS" appears in the display. When programming, make sure the playing times for each side do not exceed the length of one side of the tape. Disc number Total playing time (including selected track) "STEP" and the programmed playing order appear, followed by the total playing time. Note that you cannot use Tape Select Edit for discs containing more than 20 tracks. Repeat steps 5 and 6 for tracks from the same disc or steps 4 to 6 for tracks from another disc to program the remaining tracks to be recorded on side B. The required tape length for the currently selected CD appears, followed by the total playing time for side A and side B respectively. Every time you press the button, the display changes as follows: DBFB (level) n DBFB OFF 2 Press OPEN/CLOSE or place your hand to the sliding sensor to slide the panel. The audio emphasis menu lets you select the sound characteristic according to the sound you are listening to. The personal file function (see "Making a personal audio emphasis file") lets you store your own effects. "SUR " appears if you select an effect with surround effects. Use the jog dial (or press FILE SELECT V/v on the remote repeatedly) to select the preset you desire. The spectrum analyzer display changes each time you cycle through the information display (e. [. . . ] Do not place the unit in locations where it is; -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Vibrating -- Subject to direct sunlight If the stereo system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player. Remove the CD and leave the system turned on for about an hour until the moisture evaporates. If you have any questions or problems concerning your stereo system, please consult your nearest Sony dealer. If you later want to reuse the tape for recording, cover the broken tab with adhesive tape. [. . . ]