User manual SONY LMP-H400

[. . . ] Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ] Remove the valve cap (1), then turn the gas releasing valve fully clockwise, using a Philips screwdriver (2). Hold the lamp unit with your hand, and then, pushing the lamp release lever toward the arrow direction (toward the right), pull the lamp unit straight out. Turn the gas releasing valve clockwise until a hissing sound comes out from the valve. However, if you drop the lamp or strike it without releasing gas, the lamp may burst. Hold the lamp unit tightly so that you do not drop it, because it is heavy (approx. Insert the new lamp unit straight in all the way until it is securely in place and you hear it click. Insert the new lamp unit while holding it tightly, because it is heavy (approx. â· Confirm that the lamp release lever has returned to its original position. Projector, press the following buttons on the remote control in the following order for less than five seconds each: RESET, <, , , ENTER. Tighten the four screws loosened in step 6 to secure the lamp unit to the projector. [. . . ] Attach the new air filter so that it fits into the each claws (5 positions) on the filter holder. The projector will not turn on unless the filter holder is securely closed. [. . . ]