User manual SONY KV-29FX64E

[. . . ] Unplug the TV before moving it or if you are not going to use it for several days. To prevent the TV from falling, use the supplied screws, clamps and band to secure the TV. Screw the band to the TV stand and to the provided hole at the rear of your TV. (2) Screw one clamp to a wall or pillar and the other clamp to the provided hole at the rear of your TV. [. . . ] The last adjusted sound setting from the "Sound Adjustment" option in the menu (see page 18). Some TV stations broadcast an information service called Teletext which allows you to receive various information, such as stock market reports and news. Each time you press , the screen changes as follows: Teletext t Teletext and TV t TV. If there is no Teletext broadcast, "100" is displayed at the top left corner of the screen. Press the number buttons to enter the three-digit page number of the desired Teletext page. Each time you press , the Teletext display changes as follows: Enlarge upper half t Enlarge lower half t Normal size. X (red, green, yellow, blue) Stand by for a Teletext (1) Enter the Teletext page number that page while watching you want to refer to, then press . a TV program (2) When the page number is displayed , press to show the text. Select a FASTEXT menu or the colored boxes turn off Teletext Press x (red, green, yellow and blue) that corresponds to the desired menu or page number. The FASTEXT feature can be used only when the FASTEXT broadcast is available. The MENU button lets you open a menu and change the settings of your TV. You can also cancel "Sleep Timer" and "Wake Up Timer" by turning off the TV's main power. â· If no buttons or controls are pressed for more than one hour after the TV is turned on using the "Wake Up Timer", the TV automatically goes into standby mode. The "Channel Setup" menu allows you to preset channels automatically, manually preset channels, select the TV system, label the program number and block unwanted programs. Press V or v to select either "B/G", "I", "D/K" or "M" then press . Press V or v to select the program number, then press (2) Select "Label" and press , then press V or v to select alphanumeric characters for the label. (2) Select "Block" and press , then press V or v to choose either "On" or "Off". If you preset a locked program number, that program number will be unlocked automatically. During automatic channel presetting, your TV screen will indicate "B/G", "I", "D/K" or "M" for the "TV System". After selecting "Manual Program", select the program number to which you want to preset a channel. (2) Press V or v until the program number you want to preset appears on the menu, then press . (1) Make sure either "VHF Low", "VHF High" or "UHF" is selected, then press . [. . . ] If you connect a VCR to 8 (antenna input), preset the signal output from the VCR to the program number 0 on the TV (see page 21). If your DVD player can output interlace and progressive mode signals, select the interlace (component video input) on your TV. Your TV can receive output when connecting to either 525i/60Hz or 625i/50Hz interlace signals. â· Some DVD player terminals may be labeled differently: Connect Y (green) CB (blue) CR (red) To (on the DVD player) Y CB, PB, Cb or B-Y CR, PR, Cr or R-Y If you select "DVD" on your TV screen, the signal from the T (monitor output) jacks will not be output properly. [. . . ]