User manual SONY ICF-SW7600G

[. . . ] Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To reduce the risk of fire or electric shock, do not place objects filled with liquids, such as vases, on the apparatus. Should you notice an abnormality in the apparatus, disconnect the main plug from the AC outlet immediately. CD player section Precautions Use the power source specified in "Specifications" to operate the unit. To disconnect the power cord (mains lead), pull it out by the plug, not the cord. [. . . ] In case of the alarm, the beeping of the alarm becomes louder after every few seconds in three progressive stages. Note When Alarm A and B are set for the same time, Alarm A takes precedence. Repeat step 2 to set the minute and press ALARM A or B. All the tracks are played once. Push "REP 1" (single repeat) A single track is played repeatedly. Labelled surface up "SHUFFLE" (shuffle play) All the tracks are played once in random order. "SHUFFLE REP" (shuffle repeat) All the tracks are played repeatedly in random order. Close the lid The PRESET TUNING 3 button has a tactile dot. The CD button has a tactile dot. 5 A short beep sound and the alarm mode setting is entered. To Doze for a Few More Minutes Press TUNETIME SET + or ­ repeatedly until the desired alarm mode flashes. The area number appears in the display for a few seconds and then the display returns to the current time. After the current time reappears, press TIMEZONE to check the area number. Note Though the clock is correctly set at the factory, discrepancies may arise during transport or storage. If necessary, set the clock to the correct time by referring to "Setting the Clock Manually". Note Holding down the desired PRESET TUNING button for 2 seconds or more in step 3 will replace the station previously set to the PRESET TUNING button with the station you are tuned in to. You can choose one mode among "CD", "RADIO" and "BUZZER". Set the alarm mode as follows: ­ CD: see " Setting the CD Alarm". ­ BUZZER: see " Setting the Buzzer Alarm". Press SNOOZEBRIGHTNESS. Note When replacing the battery, do not disconnect AC plug from AC outlet. Battery Warning If the unit is to be left unplugged for a long time, remove the battery to avoid undue battery discharge and damage to the unit from battery leakage. Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur. Do not expose the battery to excessive heat such as direct sunlight, fire or the like. WARNING There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Music discs encoded with copyright protection technologies Improving the Reception FM: AM: Extend the FM wire antenna fully to increase reception sensitivity. A ferrite bar antenna is built into the unit. 1 2 Using the NAP Timer (Count Down Timer) The NAP timer sounds the buzzer after a preset duration has elapsed. Every press changes the display as follows: Perform steps 1 to 5 in "To set the Alarm". Press ALARM A or B to select "RADIO" alarm mode. After the preset number flashes, "WAKE UP STATION" appears in the display. 3 About the Backup Battery To keep good time, this unit contains one CR2032 battery inside of the unit as a backup power source. The battery keeps the clock operating in the event of a power interruption. To change to daylight saving time (summer time) indication Hold down OFF ALARM-RESET and TIMEZONE until two short beeps sound. " " is displayed, "On" appear for a few seconds, and then the time changes to daylight saving time (summer time). [. . . ] In this case, consult your Sony dealer. Incorrect Do not touch the surface. Presetting Your Favorite Station --Preset Tuning You can preset up to 10 FM stations (5 stations in FM1, 5 stations in FM2), and 5 AM stations. To the line output jack or headphones jack (e. g. , portable music player) 4 5 Press ALARM A or B. To Stop the NAP Timer A short beep sounds and "WAKE UP VOLUME" appears in the display. Press NAP or OFF ALARM-RESET to turn off the buzzer. Press TUNETIME SET + or ­ to adjust the volume. You can also adjust the volume using VOLUME + or ­. To Deactive the NAP Timer Press NAP. " " goes off in the display. Setting the Brightness of the Backlight and Illumination By pressing the SNOOZE/BRIGHTNESS button, you can select the brightness level of the backlight and illumination. The brightness level of the backlight changes in conjunction with that of the illumination. 6 Press ALARM A or B. Presetting a Station 1 Follow steps 1 to 3 in "Listening to the Do not stick paper or tape on the surface. Note on DualDiscs A DualDisc is a two sided disc product which mates DVD recorded material on one side with digital audio material on the other side. [. . . ]