User manual SOLAC AS3260

[. . . ] This appliance is not to be used by persons (or children) whose physical, sensorial or mental capacities are impaired, or who have no experience or knowledge, unless supervised or instructed in the use of the appliance by a person responsible for their safety. In the event of any anomaly in the cord or any other part of the appliance, do not use it and take it to an authorised service centre. Do not use any parts or accessories not supplied or recommended by SOLAC. Before plugging the appliance into the mains, check that the indicated voltage is the same as in your home. [. . . ] See the following section (Cleaning and Conservation) 2 Insert the flexible hose (13) into the connection (10) until it clicks into place When you want to remove the hose, press the release tabs (12) at the same time. It can be used on all types of floors, as it is retractile and can adapt to the surface to be cleaned. to change the cleaning position of the brush , press the brush button (30) with your foot. We recommend cleaning hard floors, wood and parquet with the fibre brush extended, and cleaning carpets and rugs with the fibre brush retracted. On delicate surfaces use the tip with its brush positioned on the edge. To do this, slide the small inserted brush towards the front of the tip while pressing the tab (fig. The length of the telescopic tube can be adjusted (17) by sliding the adjustment button (18) while moving both parts of the telescopic tube. 7 Adjust the suction power by turning the power control (3) to the required power level (fig. If you need more suction power for carpets or very dirty surfaces, turn the power control to the MAX position. ) You can also adjust the suction power by opening or closing the regulator on the handle (16). (Opening the valve reduces the power and closing it increases the power). ) If, while using the appliance, you hear a sharp whistle unlike the usual sound, turn it off and unplug it. ) Turn the air intake hose cover (10) anti-clockwise and check it is not blocked (fig. , This appliance has a position known as "horizontal parking", which can be used for pausing from time to time during cleaning. This position is achieved by holding the telescopic tube by the hook in the groove (4) of the appliance body. , If you want, you can place the tip (14) and the furniture brush (28) in the accessoryholder. 9 Once you have finished, switch the appliance off by pressing the button (5). Hold the cord plug in your hand to prevent it from banging against the vacuum cleaner housing. If for any reason the vacuum cleaner should overheat, the thermostat will automatically shut off the appliance. If this should happen: 1 Press the on/off switch (5) and unplug the appliance from the mains. [. . . ] Gently tap the outlet filter against the side of the waste bin to remove any excess dirt and dust. Position the mark on the cover facing the mark and turn clockwise to mark . ) Clean the appliance before using it for the first time, immediately after each use and After not using it for a long period of time. You will thus ensure the correct operation of the appliance and prolong its useful life. [. . . ]