User manual SMEG KSEG72

[. . . ] : Montage - Installation - Monteren - Montaggio - Fijación - Montagem - Ìîíòàæ A. . . B. . . C. . . D. . . E. . . : Demontage - Démontage - Dismounting - Demonteren - Smontaggio Desmontaje - Desmontagem - Äåìîíòàæ 4 GB Description of the hood - Fig. [. . . ] The release the grease filter support from the hood, pull the release buttons B (Fig. To extract the metal grease filter from the support grill, pull from right to left and extract the grease filter. Attention Failure to observe the instructions for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Replacing the lamp - Fig. Open the lamp holder compartment by turning the clasps F for the protective shield for the lamps in the counter-clockwise direction. Replace faulty lamp with one of an equal rating and kind. 10 GB According the cooker hood you own: Lamp 40W max (E14) or Neon lamp 14W max or PL lamp 11W max (model with 1 PL lamp) or PL lamp 9W max (model with two PL lamps) 4. Before calling for repair service because the hood fails to light up, make sure the lamps are well inserted. Installation These minimum distances between hobs and grease filter must be observed: Minimum 650 mm - electric hobs Minimum 750 mm - gas or mixed hobs. Electric connection (Not for UK) Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood It is advisable to call a qualified technician to make the electrical connection. If you intend to connect it directly to the electric mains, remove the plug and fit an approved bipolar switch with a minimum contact opening of no less than 3mm. If the plug is not accessible once it has been inserted in the socket, it will however be necessary to fit an approved bipolar switch with a minimum contact opening of no less than 3mm. Appliance without plug Fit an approved plug or an approved bipolar switch with a minimum contact opening of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observer the above instructions. Warning! -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. The use of an unprotected flame is dangerous for the filters and could cause fires. [. . . ] If the hood is supplied with carbon filter, then it must be removed. Filter version The air is filtered through a carbon filter (for its installation see paragraph "Carbon filter") and recirculated into the room. If the hood is not supplied with carbon filter, then it must be ordered and mounted. [. . . ]