User manual SIMRAD PI SEINESOUNDER TRAWLERS QUICK REFERENCE GUIDE REV B
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SIMRAD PI SEINESOUNDER TRAWLERS. We hope that this SIMRAD PI SEINESOUNDER TRAWLERS user guide will be useful to you.
You may also download the following manuals related to this product:
SIMRAD PI SEINESOUNDER TRAWLERS QUICK REFERENCE GUIDE REV B (1288 ko)
Manual abstract: user guide SIMRAD PI SEINESOUNDER TRAWLERSQUICK REFERENCE GUIDE REV B
Detailed instructions for use are in the User's Guide.
[. . . ] Quick reference guide Simrad PI SeineSounder for trawlers
Purpose
The Simrad PI SeineSonder does two jobs at the same time. From its position on the trawl's headrope it will measure the depth from the sea surface and the height over the seabed.
Daily operation
A
Once installed and put to use, the sensor will automatically be switched on once the waterswitch (the SHORT bolt) is activated. [. . . ] To change the sensor setup (channel selection), use the PI Configurator utility. The sensor update rate controls how often the sensor reads and reports the
height. Fast: Recommended for new equipment, or if you are not familiar with the bottom conditions. System configuration The sensor must be configured with
to unique sensor numbers. Select the same update rate for both, and use channel numbers according to the sensor's configuration. Set it to Level 9 if you have noise problems from other hydroacoustic sources. Note that this filters will influence the signal spectrum shown in the Status display. We recommend that you set the sensor filter to Light.
Numerical presentation On the PI display, you must use two channels to receive the information from the SeineSounder. If the height or depth is increasing or decreasing, this is shown with two arrows and the variation in meters per minute. You can also see the depth and height changes as a function of time in a graphical presentation. If the height is out of range, the displays shows ???.
AB (A) Sensor identification (B) Unit of measurement D1 [m] (C) Depth F (D) Depth change/ minute H (E) Arrow indicates that H1 [m] the depth is increasing (F) Visual alarm G (G) Sensor transmission indicator (H) Interference warning (I) Height (J) Height change/minute (K) Arrows pointing "out" means that the depth is increasing, arrows pointing "in" means that height is decreasing
(CD012205D)
C
D
E
43. 5 6 21. 8 1
I J K
Mounting Location: Place the sensor where you wish to monitor the height. This is normally aft of the headrope at the center of the net.
Ensure that you mount the sensor with the reverse side (D) and the echo sounder transducer (E) pointing towards the bottom! [. . . ] The sensor must be properly secured to prevent it from moving sideways or rotate during use. Make sure that you have best possible free view between the sensor and the bottom, and between the sensor and the vessel.
NOTE!
(CD012207C)
E D
For bottom and pelagic trawl applications, use the SHORT key bolt!
313699 / Rev. B / October 2007
Simrad
Kongsberg Maritime AS Strandpromenaden 50 P. O. Box 111 N-3191 Horten, Norway
Telephone: +47 33 03 40 00 Telefax: +47 33 04 29 87 www. simrad. com simrad. sales@simrad. com [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SIMRAD PI SEINESOUNDER TRAWLERS
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SIMRAD PI SEINESOUNDER TRAWLERS will begin.