User manual SIEMENS SK76M530EU/07 INSTALLATION INSTRUCTIONS

[. . . ] There is a risk of suffocation from collapsible boxes and film. m Warning Knives and other utensils with sharp points must be placed in the cutlery basket with the points downwards or horizontally on the knife shelf *. * depending on model Children in the household ­ If fitted, use the childproof lock. These may cause chemical burns in the mouth, throat and eyes or asphyxiation. The water in the rinsing compartment is not drinking water and could contain detergent residue. Installation Read the "Installation" chapter to learn how to install and connect the appliance correctly. In daily use ­ Use the dishwasher only in the household and only for its designed purpose: for washing domestic dishes. [. . . ] If the turbidity is greater, the water is drained and is replaced with fresh water. In the automatic programmes the temperature and running time can also be adjusted to the degree of soiling. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press 8 + or ­ button until the displayed time corresponds with your requirements. ­ To delete timer programming, press the 8 + or ­ button until ` : is indicated on the digital display. You can change your programme selection at any time until the programme starts. Switching on the appliance ­ Turn on the tap fully. This programme remains selected if no other programme button 0 is pressed. The programme starts running. End of programme The programme has ended when the value : is indicated on the numerical display `. Switching off automatically after the end of the programme * * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). : : : ­ ­ ­ ­ ­ Appliance does not switch off automatically Off after 1 min Off after 120 min Close the door. Press programme button # until the factory set value : is indicated on the digital display `. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display `. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 12 en To change the setting: ­ Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). ­ Remove the spray arm upwards. Troubleshooting The majority of faults which could occur in daily operation can be rectified by the user. The following overview will help you locating the causes and gives helpful advise to eliminate them. Note If the appliance stops during dishwashing or does not start for no obvious reason, first run the Abort programme function (Reset). (See chapter entitled "Dishwashing") ­ Clean the spray arm under running water. ­ Lock the spray arm into position. If on the digital display ` an error code (: to : ), always disconnect the appliance from the power supply and then turn off the tap. You can rectify certain faults yourself (see following fault description), for all other faults please contact customer service and state the indicated fault :XX. m Warning m Warning Don't forget: Repairs may be carried out by technicians only. If a component has to be replaced, ensure that only original spare parts are used. Improper repairs or use of non-original spare parts may cause considerable damage and put the user at considerable risk. 15 en Waste water pump Large food remnants in the rinsing water not retained by the filters may block the waste water pump. In this case: ­ First disconnect the appliance from the power supply. ­ Loosen screws on the pump cover (Torx T 20) and pull off. . . . Terminate the programme (see chapter entitled "Terminating the programme (Reset)") and start all over again. [. . . ] Ensure that the fresh-water connection is not kinked, crushed or twisted. ­ When replacing the appliance, always use a new water supply hose. Inlet rate: minimum 10 litres/minute Water temperature: cold water; hot water max. temperature 60 °C. Warm water connection * * depending on model The dishwasher can be connected to cold or hot water up to max. [. . . ]