User manual SDMO VARIO 1000I

[. . . ] Keep it safe throughout the generating set's service life and always adhere to the safety advice and the usage and maintenance instructions contained in it. IMPORTANT The information contained in this manual is taken from technical data available at the time of print (the photos shown in this manual are not legally binding). In line with our policy of continually improving the quality of our products, this information may be amended without warning. On request, we can supply our original manuals in French via our website (www. [. . . ] Performing the maintenance operations Before carrying out any maintenance operation: - switch off the generating set - disconnect the spark plug cap. IMPORTANT Only use original parts or equivalent parts to prevent damage to the generating set. To perform proper maintenance operations, it is necessary to open the access cover or undo the inspection flap on the generating set; close or retighten them as soon as these operations have been performed. 1 Top up the oil The used oil and filter must be recycled or eliminated according to the local regulations in force. In order for the drain operation to be more effective, it is advisable to run the generating set for around ten minutes before the drain operation in order to make the oil more fluid. Tilt the generating set slightly to drain the oil into a suitable container. Once drainage is complete, fill up with the recommended oil (see Specifications), and check the level. 2 Cleaning the screen filter RISK OF EXPLOSION Respect the local regulations in force concerning the handling of petroleum products. DANGER Ensure that the vapours have dispersed before starting the generating set. Use a low-pressure compressed air gun to blow air on the screen filter from the outside inwards. Refit the screen filter and carefully screw the fuel tank cap back in. 3 Replace the fuel filter RISK OF EXPLOSION Respect the local regulations in force concerning the handling of petroleum products. DANGER Ensure that the vapours have dispersed before starting the generating set. Note the fitting direction of the filter and remove the fuel filter by releasing the hose clamps (C?1/4). Fit the new fuel filter in the correct fitting direction and reconnect the hoses, securing them with the clamps. Wipe away any traces of fuel with a clean cloth and check that there are no leaks. 4 Clean or replace the air filter Never use petrol or flammable solvents for cleaning the air filter element (risk of fire or explosion). Remove the filter element (D?2) and check the type of clogging: Moist/oily clogging: Dry clogging: ?Check the condition of the filter element: replace it if it is at all damaged. 5 Clean or replace the spark plug Open the spark plug access cover (E?1) and fit the spark plug with the help of a plug spanner (supplied). Check the condition of the spark plug: If the electrodes are worn out or if the insulator is cracked or chipped: Or else: ?Fit the new spark plug and hand screw it so as not to cross-thread With a plug spanner, tighten 1/2turn after the plug seating to compress the washer. [. . . ] The generating set or component(s) replaced under warranty become the property of SDMO Industries. LIMITATIONS OF THE WARRANTY The warranty applies to generating sets which have been installed, operated and maintained in accordance with the documentation supplied by SDMO Industries and, in the case of a generating set malfunction, when this is due to faulty design, manufacture or materials. SDMO Industries does not guarantee the performance levels of the generating set, nor its operation or reliability, for any specific purpose. Under no circumstances can SDMO Industries be held responsible for any consequential loss, whether or not arising out of material damage, such as and in particular, but not exclusively: operating losses, expenses or other costs of whatever nature, as a result of the nonavailability of the generating set. [. . . ]