User manual SDMO ALIZE 3000 2800W

[. . . ] We recommend that you read this manual carefully and follow the safety and maintenance advice and user instructions for your generating set very closely. The information contained in this manual is taken from technical data available at the time of print. In the intention of permanently improving the quality of our products, this information may be amended without warning. Pictograms and plates on the generating sets and what they mean Danger Warning: risk of electric shock Warning: the generating set is supplied without oil. [. . . ] 10 Danger of moving parts Never go near a moving part that is in operation if you have loose clothing or long hair that is not enclosed in a protective hair net. Do not try to stop, slow down or impede a moving part when it is in operation. 11 Capacity of the generating set (overload) Never exceed the rated load of the generating set (in Amps and/or Watts) when it is running continuously. Before connecting and operating the generating set, calculate the electrical power required by the electric appliances (in Watts). This electrical power rating is usually found on the manufacturer's plate on bulbs, electrical appliances, motors etc. The sum total of power required by these appliances should not exceed the nominal power rating of the generating set. 12 Operating conditions The stated outputs of the generating sets are obtained in example conditions according to ISO 3046-1: +27°C, 100 m above sea-level, humidity level equal to 60 % or +20°C, 300 m above sea-level, humidity level equal to 60 %. Performance is reduced by approximately 4 % for every additional 10°C and/or approximately 1 % for every additional 100 m in altitude. Checking the oil level Always check the engine oil level before starting. Tasks such as topping up the oil should be carried out with the generating set on a horizontal surface. Checking the fuel level Stop the motor before filling up with fuel and fill up in a well-ventilated area. Do not smoke, or bring naked flames or sparks near to the area where you are filling up with fuel or where the fuel is stored. Do not overfill the tank (there should not be any fuel in the filler neck). When you have filled up, ensure that the tank cap is closed correctly. Before starting up the generating set, and if any fuel has been spilt, make sure that it has dried and that the vapours have cleared away. A) and fill with fuel until "F" is displayed: Unscrew fuel tank (no. Earthing the generating set To earth the generating set, use a 10 mm2 copper wire attached to the generating set earth connection and to an earthing rod of galvanised steel set in the ground to a depth of 1 metre. This also dissipates the static electricity that builds up in the electrical machines. Positioning the generating set for operation Place the generating set on a flat, horizontal surface which is firm enough to prevent the set sinking down (under no circumstances should the set tilt any direction by more than 10°). Choose a site that is clean, well-ventilated and sheltered from bad weather, and store the additional supplies of oil and fuel within close proximity, although respecting a certain distance for safety. Note: Do not use the choke when the engine is warm or when the atmospheric temperature is high. A) correctly and pull it slowly until some resistance is felt, then let it return gradually. [. . . ] Cleaning the generating set Remove all dust and debris from around the exhaust and clean the generating set using a cloth and a brush (cleaning with a water jet is not recommended, and cleaning with high-pressure cleaning equipment is forbidden). Check the general condition of the generating set and, if necessary, replace any faulty parts. Storing the generating set Generating sets which are to remain unused for a long period of time must undergo certain procedures, in order to keep them in good condition. Clean the exterior of the generating set and apply a rustproofing product. [. . . ]