User manual SANYO LNSS02 INSTALL GUIDE
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SANYO LNSS02. We hope that this SANYO LNSS02 user guide will be useful to you.
Manual abstract: user guide SANYO LNSS02INSTALL GUIDE
Detailed instructions for use are in the User's Guide.
[. . . ] LNS-S02
LENS REPLACEMENT AND INSTALLATION PROCEDURE
NOTES ON LENS INSTALLATION
Lens installation should be performed by the qualified service personnel. [. . . ] Pull down the lower lens cover while pushing the part D, then remove it. D D A B
Fig-1
LOWER LENS COVER
2
REMOVE THE COVER PLATE OF THE LENS COVER. (At the step 4 , insert the light-block sheet in the same position as the removed cover plate has been placed. Mount the lens on mounting bracket of the main cabinet with 4 screws. Use the screws included with the lens. Connect the lead connector of the lens motor to the "K16B" on the circuit board as shown in figure-4. Fasten the lens motor lead at the A, B points with wire holder as shown in figure-4.
ATTACHED DRIVER LENS MOTOR
LENS MOUNTING BRACKET
Fig-3
p Figure shown inside of the cabinet. (D) (D)
LENS MOTOR
(D)
(D)
B A WIRE HOLDER LENS MOTOR LEAD CONNECTOR " K16B"
Fig-4
4
INSTALL THE LIGHT-BLOCK SHEET. (See figure-5)
Set the light-block sheet, so that the large rounder side is set over the lens.
Install the light-block sheet around the lens as shown in the illustration. [. . . ] Insert the upper part lens cover and fix them with screws A (4 screws). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SANYO LNSS02
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SANYO LNSS02 will begin.