User manual REMINGTON SCC-100

[. . . ] Never drop or insert any object into any of the appliance's openings. Do not use outdoors or operate where aerosol (spray) products are being used, or where oxygen is being administered. Do not use this appliance with a damaged or broken cutter unit, as injury may occur. To disconnect, turn all controls to OFF, then remove adapter from outlet, then detach power cord from the clipper for storage. [. . . ] However, if the clipper is not going to be used for an extended period (2 weeks), unplug the unit and recharge when resuming use. To use the balding comb, simply begin trimming your hair with a fully-charged clipper. As you become familiar with the settings, you can then select your desired length setting. NOTE: The adjustable guide comb must be attached to the clipper in order to use the hair length selector. While holding clipper in one hand and holding the zoom wheel to prevent it from turning, gently pull the comb away from the clipper. While holding the clipper in one hand, and holding the zoom wheel to prevent it from turning, slide the comb over the top of the clipper until it clicks into position. NOTE: The combs can only be placed on the clipper one way; if the comb does not fit properly, remove and reverse it. The Shortcut Clipper has an adjustable guide comb that lets you change trim lengths simply by rolling the clipper's zoom wheel. Roll the zoom wheel toward the top of the clipper to adjust for longer length, and toward the bottom of the clipper for shorter length. Allow the clipper to cut through the hair without moving it too quickly. Use short strokes when cutting, and initially use the longest setting. To trim around the ears and short hairs at the nape of the neck simply press the release button and slide the pop-up detail trimmer outward. Holding the clipper as shown, lightly stroke upward making sure you are taking off the desired amount of hair. When completed, move clipper over and cut down the head to the nape of the neck. The SCC-100R is a bidirectional hair cutter so you can cut in either direction. Make sure the length of the hair is trimmed to the same length on both sides of the head. To cut the hair at the top of the head, cut from the front to the back in both directions until the hair is cut to the desired length. The hair clipper shall be detached from the power supply cord before cleaning. This appliance is a washable product, the hand-held part of which may be cleaned under water. First remove the attached comb from the clipper by pulling it firmly away from the blades. [. . . ] Warrants this product against any defects that are due to faulty material or workmanship for a two-year period from the original date of consumer purchase. If the product should become defective within the warranty period, we will replace it free of charge. Return your product and sales receipt with your name, address and day time phone number to: Remington Returns Center, 507 Stokely Dr. This warranty does not cover products damaged by the following: Accident, misuse, abuse or alteration of the product Servicing by unauthorized persons Use with unauthorized accessories Connecting it to incorrect current and voltage Wrapping cord around appliance causing premature wear & breakage Any other conditions beyond our control No responsibility, obligations, or liability is assumed for the installation or maintenance of this product. [. . . ]