User manual REMINGTON HC-600

[. . . ] Do not use outdoors or operate where aerosol (spray) products are being used, or where oxygen is being administered. Make sure the cord is disconnected from the clipper while storing this appliance and cord in a moisturefree area. Do not use this appliance with a damaged or broken cutter unit, as injury may occur. To disconnect, turn all controls to OFF, then remove adapter from outlet, then detach power cord from the clipper for storage. Do not use an extension cord or a voltage converter with this appliance. [. . . ] Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little at a time. STEP 2 ­ Back of the head ­ Diagram 2 With the 12mm or 18mm Guide Comb attached, cut the hair at the back of the head. STEP 3 ­ Side of the head ­ Diagram 3 With the 3mm or 7mm Guide Comb attached, trim sideburns. Then, change to the longer 9mm Guide Comb and continue to cut the top of the head. With the 18mm or 25mm Guide Comb attached, cut hair on top of the head against the direction in which the hair normally grows. Cut over the hand comb with the hair lifted or hold the hair between the fingers and cut it to the desired length. Always work from the back of the head. 3 4 SHORT TAPERED STYLES ­ "FLAT TOPS" & SHORT CUTS 1. Starting with the longest Guide Comb attached (25mm), cut from the back of the neck to the crown. Hold the Guide Comb flat against the head and slowly move the clipper through the hair, as shown. Use the same procedure from the lower side to the upper side of the head, as illustrated. Then cut the hair against the direction in which it grows and level with the sides. To give a "flat top" look, the hair on top of the head must be cut over the top of a flat comb 4. Use a closer Guide Comb to taper the hair down to the neckline as desired. Cleaning & Maintaining Your Clipper AFTER EACH USE High PrecisionTM Hair Clipper is washable enabling use in the shower and ease of cleaning. Therefore, to maintain the performance of the cutters and trimmer, oil lightly before and after each use. Be sure the clipper is turned off when applying the oil. INSTRUCTIONS FOR HAIR CUTTING Before starting the cut 1. Seat the person so that their head is approximately at your eye level. Before cutting, always comb the hair so it is tangle free and as it is naturally worn. Hair must be dry. 2 STEP 5 ­ The finishing touches ­ Diagram 5 1. Use the clipper with 5 out an attachment comb for close trimming around the base and sides of the neck. When using the ear comb guide, angle the clipper and lightly stroke around each ear towards the back of the neck. To produce a clean straight line at the sideburns, reverse the hair clipper. Press the reversed clipper at right angles to the head, tips of the blades lightly touching the skin and then work downwards. 6 7 28116_HC-600_IB 9/1/05 10:25 AM Page 8 How to Use EVERY SIX MONTHS At regular intervals the Blade Set should be removed and cleaned. [. . . ] involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. The following procedure should be followed for battery removal: Make sure your clipper is unplugged from any outlets so you don't risk. Using a phillips head screw driver, remove the 2 screws on the back of the fixed blade. Grasp bottom portion of the clipper with one hand and top portion with the other hand. You may need to twist them slightly or use a flat screwdriver to pry them apart. Pull up or pry up on the battery pack and twist to remove it. 8 9 28116_HC-600_IB 9/1/05 10:25 AM Page 10 Performance Guarantee Full Two-Year Warranty Spectrum Brands, Inc. [. . . ]