User manual PVG SENDAI 250

[. . . ] We also recommend doing this in highly insulated or draught-free rooms and/or at altitudes above 1, 500 metres. In this way, the risk of harmful accidents at accidentally touching the top plate is considerably decreased. Only use Class C1 paraffin fuel in accordance with BS2869 Part two, or equivalent. Your heater has been designed for use with high-quality water-free pure paraffin oil. [. . . ] Before igniting the heater, always check the fuel indicator ² to see whether the removable tank needs filling up. Follow the procedure below: Turn the knurled wick adjustment knob return to the startposition. Release the ignition button as soon as a flame is visible in the combustion chamber ¿. If the heater has been used only a few times and the wick adjustment knob is not locked, first turn the wick adjustment knob (Fig. L) completely left, before putting the wick in the highest position for ignition (Section C). Apply more pressure you may turn it slightly further; however, it will automatically After having ignited the heater, always check whether the combustion Chamber ¿ is level, by sliding it slightly to the left and the right by its handle ´ (Fig. If the combustion chamber is not level, this will cause smoke and soot to develop. After you have ignited the heater, it will take 10 to 15 minutes before you can check whether the heater is burning well. Too high a flame may cause smoke and soot, whereas too low a flame causes smells. The page opposite the folding page shows the minimum and maximum permissible burning heights of the flame (Fig. The flame can be slightly adjusted with the knurled wick adjustment knob · Burning that is too low may be caused by: insufficient fuel poor fuel quality insufficient ventilation wastage of the wick (fill the tank) (contact your dealer) (put window or door ajar) (contact your dealer or replace the wick, refer to section L) This heater is fitted with a safety system that ensures that it switches off if you lift the exchange tank out of the heater. To switch the heater on again, put the exchange tank back and follow the steps in chapter C. If any malfunctioning cannot be solved from the directions below, please contact your dealer. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Use the handle ´ to put it level, until you can easily slide it slightly to the left and to the right and the chamber is level. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). Before you refilled the tank, the heater had burnt up almost all the fuel. After having refilled and replaced the removable tank, wait for 30 minutes before igniting the heater. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). THE HEATER IS BURNING TOO HIGH You are using an incorrect, too volatile type of fuel. Refer to THE RIGHT FUEL (See Section 'What you need to know in advance'). It is, however, important that you remove dust and stains in time with a damp cloth, because otherwise these may cause stains that are hard to remove. [. . . ] The warranty will only apply, when you present the original, dated proof of purchase, provided no changes have been made to it. The warranty will not apply to damages caused by actions not in compliance with the Directions for Use, neglect, and the use of an incorrect type of fuel, or fuel past its use-by date. Transportation costs and the risks involved during the transportation of the heater or heater components will always be the responsibility of the purchaser. In order to avoid unnecessary costs, we recommend that you always read the 'Directions for Use' carefully first. [. . . ]