User manual PROGRESS MULTI 4 IN 1

[. . . ] This appliance complies with the following EC directives: 73/23/EC dated 21. The mains circuit for the socket used must be protected with a fuse with a rating of at least 10 A. Avoid running over the mains lead with the appliance or the vacuum brush. [. . . ] Toner dust from laser printers and copiers must not be vacuumed using normal household vacuum cleaners. This is a domestic vacuum cleaner and should only be used to vacuum dry dust. The manufacturer is not liable for any damage caused by incorrect use or operation. Do not vacuum matches, glowing ashes or cigarette ends using the appliance. Avoid picking up hard, pointed objects as these may damage the appliance or the paper filter. Do not expose the appliance to the effects of the weather, humidity or sources of heat. Should the mains lead be defective, the complete cable roller must be replaced by PROGRESS customer service or an authorised repair centre. Repairs to electrical appliances may only be carried out by qualified specialists. Improperly effected repairs may result in significant risk to the user. The cover can be opened by pressing the button and folding back until it locks. HEPA filter further supplies available from Progress customer service. Hygienic filter change: When removing the full filter bag, pull the closing tab to automatically close the opening. Bags full of normal household dust may be disposed of with household waste. Cleaning As required, wipe the housing and the paper filter compartment with a damp cloth. Occasionally vacuum the floor nozzle and brushheads with the crevice nozzle. The appliance can be switched on again after approximately 30 minutes. The fuse has blown The fuse may blow if you use other electrical appliances with high power consumption on the same electric circuit at the same time as the vacuum cleaner is in use. This can be avoided if you set the electronic power adjuster to the lowest power level and then select a higher level after switching the appliance on. [. . . ] This can be avoided if you set the electronic power adjuster to the lowest power level and then select a higher level after switching the appliance on. Your vacuum cleaner can be fitted with a gentle startup control which reduces the starting current to the motor and therefore prevents the electric circuit cut-out being triggered under normal conditions. It is possible that there will be a delay of about 4 seconds in the appliance starting up on the lowest power level. [. . . ]