User manual PROGRESS DIAMANT 812.6

[. . . ] Equipment packaging: The cardboard packaging can be deposited at a waste paper recycling point. Recycling the appliance at the end of its life: The plastic components all carry a material identification marking so that, like the other materials, they can be recycled at the end of the life of the appliance. [. . . ] Join the suction hose handle firmly to the suction tube. Attaching the suction hose Insert the suction hose connector in the suction inlet. Press the release button and pull out the connector in order to remove the suction hose. Connecting the suction tubes Join the two tubes. Mains connection/Cable rewind The mains cable is in the cable compartment. Press the foot button; the cable rewinds automatically when vacuuming has been completed. Using the nozzles Adjust the Telescopic Tube (depending on model) Using the floor nozzle* For the daily care of carpets and hard floors. Without being changed over manually, the floor nozzle is entirely suited for daily vacuuming of carpets and hard floor surfaces such as parquet, tiles, linoleum, etc. 10 Using the floor nozzle* For the daily care of carpets and hard floors. The brushes can be extended for smooth floors and retracted for carpets. Upholstery nozzle For vacuum cleaning all upholstered furniture, mattresses, etc. The thread lifting strips on the nozzle even pick up thread and lint. Switching on Switching on and off You can switch the appliance on and off by pressing the On/Off button. Power adjustment: Crevice and upholstery nozzle stored in the appliance For specific cleaning requirements, two additional parts are included with the vacuum cleaner in an integrated accessories compartment*. The nozzles may be attached to the suction tube or the handle on the suction hose, depending on requirements. Power adjustment - Rotary control* The suction power can be varied to suit individual vacuuming requirements using the electronic power adjuster. Crevice nozzle For vacuuming crevices, gaps and corners. *depending on model Power adjuster Secondary air regulator* Using the regulator on the handle, you can reduce the suction power, e. g. The wider you open the regulator, the lower the suction power at the nozzle becomes 11 Maintenance and cleaning Prior to maintenance or cleaning, ensure that the appliance is switched off and that the mains plug has been removed from the socket: Insert the new paper filter as far as it will go in the guide rails; only then can the lid be closed. Changing the microfilter We recommend replacing the microfilter at each fifth paper filter replacement, and at the latest when there is a clean dust bag and the dust level indicator is completely red with the nozzle raised. Changing the paper filter The paper filter must be replaced if the window on the filter replacement indicator is completely red when the appliance is operating at maximum power and the nozzle is raised from the floor. The paper filter should be replaced even if it does not appear to be full because fine dust can block the pores in the surface of the filter. Open the lid and fold up. Remove the used microfilter by means of the clean hygienic tabs (figure) and dispose of it with the household waste. Insert the new microfilter and close the cassette. The cover can be opened by pressing the button and folding back until it locks. [. . . ] the motor thermal cut-out is activated If the motor is overloaded, e. g. due to a full filter bag or blocked accessory, the thermal cut-out shuts down the motor. [. . . ]