User manual PIONEER XR-P760F

[. . . ] ⷠAlways drive carefully without relying too much on this product. ­ If the rear view camera comes loose while you are driving it may cause an accident. ⷠThis device is designed for use ONLY with Pioneer unit with rear camera input. Before continuing setup, please confirm you are using the "Reverse mode" to view this screen. [. . . ] When performing this procedure starting from "First Time Setup", proceed to step 5 of "First Time Setup". When performing this procedure starting from "Changing Basic Settings or Other Settings", proceed to step 5 of "Changing Basic Settings or Other Settings". Move the vehicle forward from the location where it has been parked to the location where the photographs are to be taken. Do not wash your car with an automatic car wash or high-pressure water as it may result in water entering the camera or the camera falling off. ⷠDo not attempt to heat the surface of the camera lens or camera lens itself with a lighter and so on when they have become frozen. This product is a rear view camera for checking the view at the rear of a car. A rear view camera is a camera that provides symmetrical images in the same way as rear and side view mirrors. Take photographs at the location where the white lines cross the dotted lines while referring to the photograph above. note: · Perform setup at a parking space having white lines and tire blocks. The setup will not be correct if the vehicle is not located in the center of the parking space. Adjust the angle so that an object (such as the tire blocks) serving as a reference along the horizontal lines is displayed. Return to step 5 of "Changing Basic Settings or Other Settings". When performing this procedure starting from "First Time Setup", proceed to section F entitled "Vertical Guideline (Width)". When performing this procedure starting from "Changing Basic Settings or Other Settings", return to step 5 of "Changing Basic Settings or Other Settings". When performing this procedure starting from "First Time Setup", proceed to step 6 of "First Time Setup". When performing this procedure starting from "Changing Basic Settings or Other Settings", return to step 5 of "Changing Basic Settings or Other Settings". Adjust the inclination of the vehicle vertical guidelines (shape) when there is a considerable discrepancy with the vehicle width towards the back of the field of view. The horizontal guidelines consist of three reference lines that serve as a reference when parking (green, yellow and red lines). ⷠIn the case the "view angle" of the basic settings has been adjusted from the factory adjustment, the distances between the horizontal guidelines as shown in Fig. Select the parameter to be set with the + and ­ buttons and then press the ENTER button. Adjust the horizontal of the rear view camera image as viewed from the location where the rear view camera is installed. When performing this procedure starting from "First Time Setup", proceed to section B entitled "Position (Rotate)". [. . . ] This strip will indicate the centerline of the vehicle and will be used in both the Basic Settings and Advanced Settings. Discrepancies in distance and the course over which the vehicle is traveling may occur between the horizontal guidelines on the screen and actual road surface in the following situations. When there is a steep downgrade behind the vehicle: When there is a steep downgrade behind the vehicle, the horizontal guidelines appear farther to the rear than the actual distances. When there is an obstacle present on a steep downgrade, the obstacle appears to be closer than it actually is. [. . . ]