User manual PIONEER XR-J11

[. . . ] Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. The wires in this mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live If the plug provided is unsuitable for your socket outlets, the plug must be cut off and a suitable plug fitted. The cut-off plug should be disposed of and must not be inserted into any 13 amp socket as this can result in electric shock. [. . . ] If forced ejection is performed while the disc is rotating; ÷ As the disc will be ejected outside the CD player rotating, it may hit your finger and cause injuries. As the disc will be rotating with the clamp unstable, it may be scratched. For the above reasons, never attempt to eject the disc forcibly while it is rotating. The provided pin is found in a groove in the bottom surface of the player. When the provided forced eject pin is inserted fully into the forced eject hole on the front panel, the loaded disc is ejected about 5-10 mm from the loading slot, making it possible to remove it by hand. When a disc is loaded or track search is performed, this function automatically sets the cue point (P. The Auto Cue function can be turned ON/OFF by pressing the AUTO CUE button. ¶ The ON/OFF status of the Auto Cue function is stored in memory when the power is turned off. ¶ When inserting a disc, keep the label-side up, and insert only one disc into the disc loading slot located in the front panel of the unit. 16) ¶ If a CD-ROM with no MP3 file in the first session is inserted, the display will read [NO TRACK] and the CD-ROM will not be played. The non-recorded portion at the beginning of the displayed track will be skipped and playback will begin instantly. ¶ When the jog dial rotation stops, the unit returns to playback mode. When the SEARCH button (1 , ¡) is released , Super-Fast search is canceled. ¶ During playback of MP3s, fast-forward/fast-reverse are supported only for tracks inside the same folder. ¶ Each time the button is pressed, the track is cued in the direction corresponding to the arrow on the button (during playback of a track, to cue playback to the beginning of the preceding track, press the 4 button twice). During playback of MP3s, the first track found in the direction pressed will be cued, and only those tracks inside the same folder are searched. If Folder Search is not performed when a CD-ROM is inserted, the tracks in the root directory only will be cued. In cases in which there are no tracks in the root directory, playback will start from the track with the smallest number in the first folder closest to the root directory. ¶ When the Auto Cue function is turned ON, the track will be set in cue standby position at the beginning of the track after cueing. When the TRACK SEARCH button (4 , ¢) is held depressed , cueing is performed continuously. If the button is held depressed for two seconds or more, the cue speed increases. ¶ By turning the jog dial in the desired search direction while pressing either of the TRACK SEARCH buttons (4, ¢), the track number will be searched corresponding to the turning of the jog dial. [. . . ] Sometimes incorrect operation may be due to a malfunction in another component. If the problem is not fixed, check the other components used with the player. If the problem still persists, contact your nearest Pioneer authorized service center or dealer for service. symptom Disc doesn't eject even when EJECT button (0) is pressed. [. . . ]