User manual PIONEER XC-L77

[. . . ] Please write this serial number on your enclosed warranty card and keep it in a secure area. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Also use to cancel operations, such as setting the clock, before the SET button has been pressed (see 5 above). 8 CD mode ­ Press to switch the sound to CD and start the disc playing (if there's one loaded). 1 Tuner mode ­ Press to switch the sound to tuner, 1 switch between AM and FM, and switch between preset station memories. 12 STANDBY/ON ­ Press to switch the unit between standby and on modes. This remote control has a feature that will allow you to locate it if you've mislaid it in the room. When REMOTE LOCATOR is switched on, clapping three times within the space of about a second will cause the remote control to beep. Although a useful function, leaving remote locator on all the time reduces the battery life of the remote. When switched on, the remote will sometimes beep if knocked or dropped -- this is not a malfunction. 1 CD function ­ Highlights when in CD player mode 2 Tuner function ­ Highlights when in tuner mode 3 Aux/CD-R function ­ Lights when in aux/CD-R mode 4 Wake up timer ­ Lights when the wake up timer is set; flashes during wake up timer playback. 8 Mono ­ Lights when the tuner is set to the mono mode (applies only to FM broadcasts). If you've followed the manual to here, you should now have your system installed with everything connected up and plugged in. This chapter takes you through using the basic features: playing CDs, listening to radio stations, and adjusting the volume, tone and balance to get the sound you want. This is mainly used for timer functions, such as the sleep timer, though you can also use the display as a clock. Unless you unplug the unit, or there's a power failure, you only need to set the clock once. You can use the STANDBY/ON button on either the remote control or the CD receiver unit to do this. The display lights and briefly indicates the current volume level before showing the current function (e. Display shows the CD player as the current function (no disc loaded) The display changes to show a date and time, with the day part of the year flashing to indicate that you can set it. Year / month / day Once you've pressed SET, the month will start flashing. After setting the year, set the month Each time you press SET, the next part of the date/time will start flashing. Correct time and date after setting Heure et date correctes après le réglage Remember: If power is interrupted, the clock display will flash until you reset it to the correct time. Here, we'll run through the basics you need to play discs in the CD player/receiver. Other features of the CD player, such as programming the track order, are covered later--see pages 29 to 34 for complete instructions on all the CD player's features. [. . . ] After choosing one of the sleep options, the display dims Not be available if a CD is playing in repeat mode (see p. If you select AUTO, then subsequently start playing something in repeat or endless mode, the sleep timer will change automatically to the 90 minute setting. If you think that there is something wrong with this component, check the points below. Investigate the other components and electrical appliances being used. [. . . ]