User manual PIONEER XC-L5

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] This is for use with the optional CD-recorder only-- see the CD-R manual for more information on this. After making sure that the system components and speakers are all connected properly, plug in the power cord to the back of the CD receiver, and the other end to a mains power outlet. Always handle the power cord by the plug - don't pull out the plug from the wall socket by the wire. On top of the power cord, and route it in such a way that it is unlikely to be stepped on or tripped over. Never tie the power cord together with other cords, or knot it in any way. Check the power cord occasionally-- if it's damaged ask a Pioneer authorized service centre or your dealer for a replacement. 3 ^ button ­ Press to play a disc, or pause a disc that's already playing (press again to restart playback). 5 Play light ­ Lights when a CD is playing 6 Standby/On button ­ Press to switch the unit between standby and on modes. Note: this unit consumes a small amount of electricity in standby mode (1 W). 7 Phones socket ­ Connect a pair of headphones for private listening. 2 SOUND ­ Press to put the $ and > buttons into tone, subwoofer level and balance control mode. Other features of the CD player, such as programming the track order, are covered later--see pages 29 to 34 for complete instructions on all the CD player's features. Place a CD, with the label face up, on to the disc tray, making sure that it is seated properly in the disc guide. You can also use the CD receiver's front panel controls: ^ closes the disc tray and starts the disc playing from the first track. CD playing with the track number and track time elapsed shown in the display. You can also use the CD receiver's front panel controls: Press ^ once to pause playback; press again to resume. You should hear snippets of sound to give you some idea of where you are in the track. 6 To skip back or forward to another track, press (but don't hold) $ or >. In step 2 above, pressing the CD button closed the disc tray and set the disc playing. In fact, pressing this button is always the quickest way to play a disc. If there's already a disc in the player, then pressing the CD button--even when the system is in standby mode--will switch the system on, switch to CD sound, and start the disc playing. On the previous page, you may have adjusted the volume while the CD was playing. [. . . ] $ SLEEP AUTO > SLEEP 90 - SLEEP 60 - SLEEP 30 - SLEEP OFF plays the current CD, tape or MD out, then switches off the system. 90, 60 and 30 options switch off the system after 90, 60 and 30 minutes, respectively; OFF cancels the sleep timer if it was previously set. The little moon indicator lights in the display to show the sleep timer is set and the display dims. To check how much time is left on the sleep timer, select SLEEP TIMER from the timer menu, then press SET. [. . . ]