User manual PIONEER XC-L11

[. . . ] These labels can be found on the rear panel of the XC-L11 and on the top panel of the M-L11. The wires in this mains lead are coloured in accordance with the following code: Blue : Brown : Neutral Live If the plug provided is unsuitable for your socket outlets, the plug must be cut off and a suitable plug fitted. The cutoff plug should be disposed of and must Not be inserted into any 13 amp socket as this can result in electric shock. The plug or adaptor of the distribution panel should be provided with a 5 amp fuse. [. . . ] For detailed instructions on using the optional MD or tape deck, see the operating instructions included with the component. If the component you connected to the analog inputs causes the sound to distort, the input level is probably too high. Volume is adjustable from zero (silence) to 36 (maximum volume) using the VOLUME + and ­ buttons on the remote. You can also adjust the bass, treble, balance and subwoofer level to get the sound you want. Start a disc playing before working through the steps below so that you can hear the effect of changes as you make them. In step 3, if more than 5 seconds goes by without you pressing a button, the system goes ahead and sets the new level for you, without you having to press SET (step 4). This mode lets you program a sequence (a playlist) of up to 24 tracks to play. Tracks can appear more than once in the playlist, or can be left out entirely. Once you take the disc out (or switch the power into standby), the playlist is lost. 1 2 If the system isn't already in CD mode, press CD then stop playback. 3 4 Select a track to add to the playlist using the 4 and ¢ buttons. If you make a mistake, press CANCEL to delete the last (most recent) track programmed. When no more tracks can be added the display shows You can only check the playlist order when the disc is stopped. Once stopped, you can step through the playlist using the 4 and ¢ buttons. If you then press 7, the total playing time of the playlist is displayed. If you want to delete the playlist without removing the disc, press 7 stop twice when the disc is stopped. Using repeat play You can set the CD player to repeat either a single track over and over, or the whole disc. ­ repeat one track · ­ turn repeat off In one track repeat mode, any track you choose will repeat. If you jump to another track using track skip, then the new track will start repeating. In all track repeat mode, whenever the end of the disc is reached, the player will jump back to the first track and continue playback. The repeat mode you set stays active until you: · Select another repeat mode, or switch repeat mode off using the menu. You can use either of the repeat modes together with the program play mode. [. . . ] When you're not using a disc, return it to its case and store upright. Avoid leaving discs in excessively cold, humid, or hot environments (including under direct sunlight). Don't glue paper or put stickers on discs, or write on them using a pencil, ball-point pen or other sharptipped writing instrument. If you can see that a disc is cracked, chipped, warped, or otherwise damaged, don't risk using it--you could end up damaging the system. [. . . ]