User manual PIONEER X-HM10-S

[. . . ] When using the standard surround speaker setup as shown in step 3, please observe the following guidelines: · Install the main front left and right speakers at an equal distance from the TV. Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen. Note: If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. Don't let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances. [. . . ] Don't let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances. For best results, extend the FM antenna fully and fix to a wall or door frame. Always be sure to follow these guidelines: · Always insert batteries into the battery compartment correctly matching the positive ª and negative · Never mix new and used batteries. ⷠBatteries of the same size may have different voltages, depending on brand. ⷠWhen disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. ⷠIn order to prevent battery leakage, remove the batteries when not using the remote control for an extended period (one month or more). If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries with new ones. ⷠDo not allow books or other objects to rest on top of the remote control, since the buttons may be depressed, causing faster exhaustion of the batteries. ⷠDo not use or store batteries in direct sunlight or excessively hot places, such as inside a car or near a heater. When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Use the supplied adhesive to attach 4 pads to the base (flat surface) of each speaker. This is a standard multichannel surround sound speaker setup for optimal 5. Attach the smaller non-skid pads to the base of each of the front speakers and the center speaker. Use the supplied adhesive to attach 4 pads to the base (flat surface) of each speaker. Listening position Surround left Surround right Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide) to connect the speakers properly. The base of each surround speaker fits into the circular groove on the top of the front speakers as shown. After testing for the slack necessary to turn the speaker (see the following step), use the groove provided to secure the speaker wire. See listening mode section in the operating instructions for more information on operations such as how to select the listening mode. Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide) to connect the speakers properly. Make sure to tighten the supplied screw as securely as possible when attaching the bracket to the back of the speaker. [. . . ] Refer to the Setting up your DVD/CD Receiver (the other part of this setup guide) to connect the speakers properly. Make sure to tighten the supplied screw as securely as possible when attaching the bracket to the back of the speaker. ⷠPlease do not attach the brackets to the center speaker. before mounting · Remember that the speaker system is heavy and that its weight could cause the wood screws to work loose, or the wall material to fail to support it, resulting in the speaker falling. [. . . ]