User manual PIONEER VSX 711D

[. . . ] Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. Installing the Receiver VENTILATION: When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 60 cm at top, 10 cm at rear, and 30 cm at each side). WARNING: Slot and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, to prevent fire hazard, the openings should never be blocked and covered with items, such as newspapers, tablecloths, curtains, etc. [. . . ] LFE attenuator setting (page 71) Specify the peak level for the LFE channel. Front speaker distance setting (page 71) Specify the distance from your listening position to your front speakers. Center speaker distance setting (page 72) Specifies the distance from your listening position to your center speaker. Surround speaker distance setting (page 72) Specify the distance from your listening position to your surround speakers. Surround back speaker distance setting (VSX-D811S only) (page 73) Specifies the distance from your listening position to your surround back speakers. Dynamic range control setting (page 73) Compress the dynamic range of the sound track. 18, 3:14 PM Setting up your receiver Konfiguration des Receivers 06 Dual mono setting (page 74) Isolate one channel when listening to discs with dual mono encoding. Surround back channel input setting (VSX-D811S only) (page 75) Specify the number of surround back inputs you have connected. Digital input settings (page 75) Specify the components to be assigned to the digital inputs (below). Speaker setting • Default setting: S (all speakers) You must let the receiver know how many speakers you have, and how big they are. The size you choose (large or small) determines how much bass is sent from the receiver to the speakers. 18, 3:14 PM 06 Setting up your receiver Konfiguration des Receivers In the display, F, C, and S refer to front, center, and surround speakers respectively. Speaker size is denoted as L for large speakers, S for small speakers, and (asterisk) if no speaker is connected. Hinweis • If the cone size (diameter) of the speaker is larger than 15 cm, set the speaker size to L. € If you’re not using a subwoofer, we recommend setting the front speakers to L. € Cycle through the available choices using ’ or ‘ and choose a configuration that matches your speaker setup. The size you choose (large or small) determines how much bass is sent from the receiver to the speakers. If you have connected a surround back subwoofer, you should select the surround back subwoofer setting (SB SUBWF) from the options. 1 FIX You can have the receiver automatically switch to Dolby Digital Surround EX or DTS-ES decoding for 6. 1 AUTO), or you can choose to listen to other kinds of sources (for example, 5. 1 encoded sources, a surround back channel will be generated, but the material may sound better in the 5. € If you chose SB in Surround back speaker setting (above), you can’t set the 6. [. . . ] € Select the correct component (use the MULTI JOG/INPUT SELECTOR dial or the MULTI CONTROL buttons on the remote). € Fully extend the FM wire antenna, position for best reception, and secure to a wall. • Connect an additional internal or external AM antenna (refer to pages 29–30). € Turn off the equipment causing the noise or move it away from the receiver. [. . . ]