User manual PIONEER VSX-521-K

[. . . ] To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the equipment on thick carpet or a bed. D3-4-2-1-7b*_A1_En D3-4-2-1-1_A1_En Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. IMPORTANT: THE MOULDED PLUG This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to BS1362. [. . . ] MUTE English Remote control operation The remote control supplied with this unit allows you to play and stop media, and perform other operations. € It must be necessary that the Bluetooth wireless technology enabled device supports AVRCP profiles. € Remote control operations cannot be guaranteed for all Bluetooth wireless technology enabled devices. BASS TRE 4 Switch on the Bluetooth wireless technology device that you want to make pairing, place it near the system and set it into the pairing mode. 5 Check to see that the Bluetooth ADAPTER is detected by the Bluetooth wireless technology device. When Bluetooth wireless technology device is connected: Bluetooth wireless technology device name appears in the receiver display. When Bluetooth wireless technology device is not connected: NODEVICE appears in the receiver display. In this case, perform the connection operation from the side of the Bluetooth wireless technology device. Pairing the Bluetooth ADAPTER and Bluetooth wireless technology device “Pairing” must be done before you start playback of Bluetooth wireless technology content using Bluetooth ADAPTER. Make sure to perform pairing first time you operate the system or any time pairing data is cleared. €Pairing” is the step necessary to register Bluetooth wireless technology device to enable Bluetooth communications. € You can also use the number buttons on the remote control to recall the station preset. TUNE TUNER EDIT MASTER VOLUME TOOLS MENU TUNE TUNER EDIT MASTER VOLUME TOOLS MENU RECEIVER SLEEP Naming preset stations PRESET PRESET ENTER For easier identification, you can name all of your preset stations. PRESET RECEIVER INPUT SELECT DTV/TV INPUT PRESET ADAPTER TUNER PORTABLE ENTER 1 Choose the station preset you want to name. The cursor at the first character position is blinking on the display. ADAPTER TUNER PORTABLE BASS TRE 3 Input the name you want. There are three ways to do this: Automatic tuning To search for stations in the currently selected band, press and hold TUNE / for about a second. The receiver will start searching for the next station, stopping when it has found one. Manual tuning To change the frequency one step at a time, press TUNE /. Tip • To erase a station name, follow steps 1 and 2, and press ENTER while the display is blank. Press TUNER EDIT while the display is blank, to keep the previous name. When you want to return to the frequency display, press DISP several times to show the frequency. [. . . ] 08 Note • Depending on the component, audio output may be limited to the number of channels available from the connected display unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations). € If you want to switch the input source, you’ll have to switch functions on both the receiver and your display unit. € Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the display every time you switch input sources. ρIf the problem still persists when connecting your HDMI component directly to your monitor, please consult the component or monitor manual or contact the manufacturer for support. [. . . ]