User manual PIONEER VMR-M770

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – – – – Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. [. . . ] There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. AFTER-SALES SERVICE FOR PIONEER PRODUCTS Please contact the dealer or distributor from where you purchased the product for its after-sales service (including warranty conditions) or any other information. In case the necessary information is not available, please contact the Pioneer’s subsidiaries (regional service headquarters) listed below: PLEASE DO NOT SHIP YOUR PRODUCT TO THE COMPANIES at the addresses listed below for repair without advance contact, for these companies are not repair locations. Information to User Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment. D8-10-2_En WARNING: Handling the cord on this product or cords associated with accessories sold with the product will expose you to chemicals listed on proposition 65 known to the State of California and other governmental entities to cause cancer and birth defect or other reproductive harm. Wash hands after handling D36-P4_A_En – 2 – SAFETY INSTRUCTIONS To ensure your personal safety and to maximize the full operating potential of your Drive, read and follow these safety precautions: ENVIRONMENT - Please do not use the unit in places with high levels of dust, high temperature, or high humidity. Please use the unit in a place where it is not subjected to vibrations or shocks. Make sure the power of the drive is turned off and wait more than one minute till the disc rotation is stopped when access the eject hole. During reading Lights During writing Lights 2 Voyant BUSY (occupé) L’état de fonctionnement est signalé comme suit: Pendant la lecture S’allume Pendant l’écriture S’allume 3 Disc Tray Open the loading tray by pressing the eject button, then place a BD, DVD or CD disc into the slit with the label facing up. About DualDisc playback A DualDisc is a new two-sided disc, one side of which contains DVD content – video, audio, etc. – while the other side contains non-DVD content such as digital audio material. The non-DVD, audio side of the disc is not compliant with the CD Audio specification and therefore may not play. It is possible that when loading or ejecting a DualDisc, the opposite side to that being played will be scratched. For more detailed information on the DualDisc specification, please refer to the disc manufacturer or disc retailer. When this unit is installed flat, 8 cm discs may be used by placing them in the 8 cm disc depression in the center of the disc tray. Proper operation and desired performance may not be achieved depending on the BIOS version and setting of your computer, or the type of Serial ATA interface used. For further information regarding computer specifications and settings, consult the Operating Instructions accompanying your computer, or contact the computer manufacturer. [. . . ] When this unit is installed flat, 8 cm discs may be used by placing them in the 8 cm disc depression in the center of the disc tray. Proper operation and desired performance may not be achieved depending on the BIOS version and setting of your computer, or the type of Serial ATA interface used. For further information regarding computer specifications and settings, consult the Operating Instructions accompanying your computer, or contact the computer manufacturer. ABOUT REGION CODES The region code can be changed ONLY 5 times, including the 1st setting. [. . . ]