User manual PIONEER TX-9100

[. . . ] Also, damage to this unit, smoke, and overheating could result from contact with liquids. If the battery is disconnected or discharged, any preset memory will be erased. Note Function setting operations are completed even if the menu is cancelled before the operations are confirmed. Important Failure to connect the red lead (ACC) of this unit to a terminal coupled with ignition switch on/off operations may lead to battery drain. [. . . ] After selecting, perform the following procedures to set the audio function. When the rear output setting is SW, you cannot adjust front/rear speaker balance. The following functions are still accessible from the unit even if the control mode is set to iPod/APP. -- -- -- -- -- -- -- -- -- Switching the text information (iPod) Pausing Fast forward/reverse Track up/down Repeat play (ONE/ALL/OFF) Random play (shuffle) (list) to use iPod menu Press M. Down to turn the iPod click wheel to the right A separate CUSTOM1 curve can be created for each source. If you make adjustments when a curve other than CUSTOM2 is selected, the equalizer curve settings will be stored in CUSTOM1. If you make adjustments when the CUSTOM2 curve is selected, the CUSTOM2 curve will be updated. When the control mode is set to iPod/APP, operations are limited as follows: -- The function settings are not available. This unit is equipped with a subwoofer output which can be turned on or off. SW SETTING 2 (subwoofer adjustment) The cut-off frequency and output level can be adjusted when the subwoofer output is on. Only frequencies lower than those in the selected range are outputted from the subwoofer. With a 2 speaker system, do not connect anything to the speaker leads that are not connected to speakers. Consult your dealer if installation requires drilling of holes or other modifications to the vehicle. Do not install this unit where: Front output Rear output Antenna input Fuse (10 A) Power cord input Wired remote input Hard-wired remote control adaptor can be connected (sold separately). Perform these connections when not connecting a rear speaker lead to a subwoofer. To power cord input Left Right Front speaker Rear speaker White White/black Gray Gray/black Green Green/black Violet Violet/black Black (chassis ground) Connect to a clean, paint-free metal location. Install this unit away from hot places such as near the heater outlet. Optimum performance is obtained when the unit is installed at an angle of less than 60°. To ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents when installing the unit. This unit can be properly installed using either front-mount or rear-mount installation. If there is enough space, use the mounting sleeve that came with the vehicle. 2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. [. . . ] Do not insert anything other than an SD memory card into the SD card slot. If a metal object (such as a coin) is inserted into the slot, the internal circuits may break and cause malfunctions. Do not use an adapter which has metal parts other than the connectors exposed. Only the first 32 characters can be displayed as a file name (including the file extension) or a folder name. [. . . ]