User manual PIONEER TS-W3004SPL

[. . . ] Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. [. . . ] Playback and volume level setting for iPod music and images can be performed from this unit or the iPod itself. tip · When using an iPod not supported by this unit, use a commercially available cable to connect the iPod to the AUDIO IN connector of this unit. Connecting your iPod Confirm what iPod models are supported This system is compatible with the audio and video of the iPod nano third generation and above, iPod classic, iPod touch and iPhone. You can confirm your software version by operating your iPod as follows: 1 Select `Settings' from the top menu. To prevent damage when connecting an iPod, always use the Dock adaptor supplied with your iPod, or a commercially purchased Dock adaptor designed for your iPod model. Consult the Apple website regarding the newest software versions and instructions on how to update your version. Some functions may be restricted depending on the model or software version. Features such as the equalizer cannot be controlled using this system, and we recommend switching the equalizer off before connecting. Pioneer cannot under any circumstances accept responsibility for any direct or indirect loss arising from any inconvenience or loss of recorded material resulting from the iPod failure. When connecting an iPod, use the `Speaker' menu's `Backlight' item to set the iPod's backlight function. When attaching the Dock adaptor, be sure to orient the front-back directions of the Dock adaptor correctly. When input is switched from iPod to another function, the iPod playback stops automatically. If the unit is set to standby when an iPod is connected, the iPod's power will be turned OFF automatically. When the iPod software version is too old, update the iPod software to the latest version. When there is no response from the iPod, update the iPod software to the latest version. 1 When the Bluetooth ADAPTER is not plugged in the ADAPTER PORT, cannot be selected even if INPUT is pressed. 2 · Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER. To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology device. Listening to Music Contents of Bluetooth wireless technology device with Your System The following operations are now possible for Bluetooth wireless technology devices, using the remote control. Bluetooth wireless technology device should be compatible with AVRCP profile. Depending on Bluetooth wireless technology device you use, operation may differ from what is shown in this table. Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet. [. . . ] When finished using the timer, set the timer function to OFF (see below). Using the sleep timer The sleep timer switches off the unit after a specified time so you can fall asleep without worrying about it. When the wake-up timer sounds if the snooze function is OFF: Press the main unit's STANDBY/ON button to stop the timer playback and turn power off. Alternately, wait for one hour (when beep is selected, wait for one minute) and playback will stop automatically and power will turn off. [. . . ]