User manual PIONEER TS-A1723I

[. . . ] The use of an improper fuse could result in overheating and smoke, damage to the product and injury, including burns. Check the connections of the power supply and speakers if the fuse of the separately sold battery wire or the amplifier fuse blows. Determine and resolve the cause, then replace the fuse with and identical equivalent. Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). [. . . ] If the temperature gets too high, the power indicator will turn off, and the amplifier will shut down. Extended use of the car stereo while the engine is at rest or idling may exhaust the battery. When this product detects something abnormal, the following functions will operate to protect the product and speaker output. The power indicator will turn off and the amplifier will shut down in the situations outlined below. En 3 Section 02 Setting the unit What’s what GM-A5602 Front side 2 FREQ (cut off frequency) control Cut off frequency selectable from 40 Hz to 500 Hz if the LPF select switch is set to ON. 3 BASS BOOST (bass boost level control) switch You can select a bass boost level from 0 dB, 6 dB and 12 dB. 4 GAIN (gain) control If output remains low, even when the car stereo volume is turned up, turn controls to lower level. If distortion occurs when the car stereo volume is turned up, turn these controls to higher level. For use with an RCA equipped car stereo (standard output of 500 mV), set to the NORMAL position. For use with an RCA equipped Pioneer car stereo, with maximum output of 4 V or more, adjust level to match that of the car stereo output. For use with an RCA equipped car stereo with output of 4 V, set to the HIGH position. Install and route the separately sold battery wire, ground wire, speaker wires and the amplifier as far away as possible from the antenna, antenna cable and tuner. 03 English to 8 W for stereo connection, or 4 W to 8 W for monaural and other bridge connection. Do not install or use this amplifier by wiring speakers rated at 4 W (or lower) in parallel to achieve a 2 W (or lower) bridged mode (Diagram B). Amplifier damage, smoke, and overheating could result from improper bridging. The amplifier surface could also become hot to the touch and minor burns could result. To properly install or use a bridged mode and achieve a 4 W load, wire two 8 W speakers in parallel with Left + and Right * (Diagram A) or use a single 4 W speaker. In addition, refer to the speaker instruction manual for information on the correct connection procedure. For any further enquiries, contact your local authorized Pioneer dealer or customer service. Connecting the speakers The speaker output mode can be two-channel (stereo) or one-channel (mono). Connect the speaker leads to suit the mode according to the figures shown below. Two-channel output (Stereo) About suitable specification of speaker Ensure speakers conform to the following standards, otherwise there is a risk of fire, smoke or damage. [. . . ] Note If speaker input wires from a headunit are connected to this amplifier, the amplifier will automatically turn on when the headunit is turned on. When the headunit is turned off, the amplifier turns off automatically. This function may not 1 2 3 4 Positive + terminal Engine compartment Vehicle interior Fuse (30 A) × 2 8 En Section Connecting the units 5 Insert the O-ring rubber grommet into the vehicle body. 4 5 6 7 Terminal screws Battery wire Ground wire System remote control wire 03 English 2 Twist the battery wire, ground wire and system remote control wire. [. . . ]