User manual PIONEER SX-J420

[. . . ] To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. -- Place all cables away from moving parts, such as the gear shift and seat rails. -- Place all cables away from hot places, such as near the heater outlet. [. . . ] When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Ground cables for this unit and other equipment (especially, high-current products such as power amps) must be wired separately. If they are not, an accidental detachment may result in a fire or malfunction. Front output Rear output (SX-J420 only) Power amp (sold separately) Power amp (sold separately) Power amp (sold separately) Connect with RCA cables (sold separately) In another type of vehicle, never connect 5* and 6*. (SX-J420 only) · When you connect the separately sold multi-channel processor (DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). When you connect the multi-channel processor to this unit, refer to multi-channel processor's installation manual for the connection method. When connecting with supplied USB cable (for AVHP4300DVD model) This product USB cable (supplied with this unit) Connect to separately sold USB device. IP-BUS input AUX input (AUX) Microphone for hands-free phoning (supplied with Bluetooth adapter) Wired remote input Hard-wired remote control adaptor can be connected (sold separately). Fix the optical cable connection box securely with the hook and loop fastener or lock tie. If the unit is loose, it disturbs driving stability, which may result in a traffic accident. If other parts are used, this unit may be damaged or could dismount itself, which leads toan accident or other problems. Do not install this unit near the doors where rainwater is likely to be spilled on the unit. Install the optical cable connection box using the hook and loop fastener in the ample space of the console box. Connect the optical cable so that it does not protrude from the main unit, as shown in the illustration. Fasten the ground lead to the protrusion on the back of the main unit. Wrap the optical cable and connection box with the protection tape and fasten with the power code using the lock tie. 1 Wrap with the protection tape 2 Fasten with the lock tie Do not use unauthorized parts as this may cause malfunctions. Consult your dealer if installation requires drilling of holes or other modifications to the vehicle. Do not install this unit where: -- it may interfere with operation of the vehicle. [. . . ] Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. Install this unit away from hot places such as near the heater outlet. Optimum performance is obtained when the unit is installed at an angle of less than 30°. Before installing this unit 1 Holder (Supplied with this unit) 2 Screw (3 mm × 6 mm) (Supplied with this unit) After inserting the holder into the dashboard, select and bend the tabs appropriate to the thickness of the dashboard material. [. . . ]