User manual PIONEER SG-9800

[. . . ] Audio and initial setup Function names and setup status are displayed. 2 Preset number/track number indicator Shows the track number or preset number. 5 Stereo (5) indicator Shows when the selected frequency is being broadcast in stereo. Important If you are using this unit in North, Central or South America, reset the AM tuning step (see Setting the AM tuning step on page 9). [. . . ] Important If you are using this unit in North, Central or South America, reset the AM tuning step (see Setting the AM tuning step on page 9). Turning the unit on and selecting a source You can select a source you want to listen to. To switch to the built-in CD player, load a disc in the unit (refer to the next page). Press SOURCE repeatedly to switch between the following sources: Tuner--Built-in CD player--AUX notes !In the following cases, the sound source will not change: -- When there is no disc in the unit. Turn off the AUX when not in use (refer to Switching the auxiliary setting on page 9). When this unit's blue/white lead is connected to the vehicle's auto-antenna relay control terminal, the vehicle's antenna extends when this unit's source is turned on. 4 To perform seek tuning, press and hold c or d for about one second and release. The tuner will scan the frequencies until a broadcast strong enough for good reception is found. % When you find a frequency that you want to store in memory, press one of preset tuning buttons 1 to 6 and hold until the preset number stops flashing. Even when the sources are off, the clock display appears on the display. # The clock display disappears temporarily when you perform other operations, but the clock display appears again after 25 seconds. Using the initial settings, you can customize various system settings to achieve optimal performance from this unit. Press FUNCTION repeatedly to switch between the following settings: Clock--FM (FM tuning step)--AM (AM tuning step)--AUX (auxiliary input) Use the following instructions to operate each particular setting. # You can also cancel initial settings by holding down SOURCE until the unit turns off. The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz. The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. When using the tuner in North, Central or South America, reset the tuning step from 9 kHz (531 kHz to 1 602 kHz allowable) to 10 kHz (530 kHz to 1 640 kHz allowable). Activate the auxiliary setting when using auxiliary equipment connected to this unit. When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error message. [. . . ] Activate the auxiliary setting when using auxiliary equipment connected to this unit. When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error message. Switch the ignition key, or switch to a different source, then back to the CD player. Do not use cracked, chipped, warped, or otherwise damaged discs as they may damage the player. [. . . ]